INST-2001 I N S TA L L AT I O N I N S T R U C T I O N S GM Multi Kit 1990-2012 APPLICATIONS See Page 2 KIT FEATURES 95-2001 • ISO DDIN radio provision 99-2001 • ISO DIN radio provision with pocket TABLE OF CONTENTS See Page 3 KIT COMPONENTS 95-2001: • A1) Radio trim plate • B1) Radio brackets • C1) Spacers 99-2001: • A2) Radio trim plate • B2) Radio brackets • C2) Spacers • D2) Pocket • E2) (4) #8 x 3/8” Phillips screws A1 B1 WIRING & ANTENNA CONNECTIONS (sold separately) Wiring Harness: Please visi
APPLICATIONS (95-2001 OR 99-2001) BUICK Century ...................................1997-2005 Le Sabre ..................................1995-2005 Park Avenue ...........................1995-2005 Rainier ...................................2004-2007 Regal ...................................... 1995-2004 Rendezvous ...........................2002-2007 Riviera..................................... 1996-1999 Roadmaster ............................ 1995-1996 Skylark ....................................
TABLE OF CONTENTS Dash Disassembly - Buick Century 1997-2005 ...........................................................4 - Buick Le Sabre 1995-2005 ..........................................................4 - Buick Park Avenue 1995-2005 ...................................................4 - Buick Rainier 2004-2007 ..........................................................13 - Buick Regal 1995-2004...............................................................4 - Buick Rendezvous 2002-2007 ................
DASH DISASSEMBLY 95-2001 OR 99-2001 Buick Century 1997-2005 Buick Regal 1995-2004 1. Remove the plastic trim piece to the left of the glove box and (1) Phillips screw exposed. Buick Le Sabre/Buick Park Avenue 1995-1999 Buick Le Sabre/Buick Park Avenue 2000-2005 1. Unsnap the climate control trim panel (from door to door) and remove (4) Phillips screws exposed. (Figure A) 1. Open drivers door and unsnap and remove dash end cap. 2. Unsnap the top edge of the knee bolster panel. 2.
DASH DISASSEMBLY 95-2001 OR 99-2001 Buick Rendezvous 2002-2007 Buick Riviera 1996-1999 1. Open center console and remove (2) screws at front of console opening. (Figure A) 1. Unsnap left side panel exposing (1) Phillips 5. Unsnap bottom edge of trim bezel, then screw to remove. while holding overhang up, unsnap and remove trim bezel by removing any 2. Remove (1) Phillips screw and unsnap right necessary harnesses. side panel to expose (1) Phillips screw 2.
DASH DISASSEMBLY 95-2001 OR 99-2001 Buick Roadmaster 1995-1996 Buick Skylark 1996-1998 1. Unclip dash panel sides and remove. 1. Remove (6) 9/32” screws inside glove box. 2. Unclip panel below steering column and remove. 2. Under glove box and drivers knee bolster, remove (2) plastic panels by turning (2) 1/4 turn fasteners per side. 3. Remove (2) 7mm screws above instrument cluster. 4. Set parking brake, turn car on, and move shifter to the lowest gear.
DASH DISASSEMBLY 95-2001 OR 99-2001 Cadillac Escalade, Escalade ESV & EXT 2003-2006, Chevrolet Avalanche/Suburban/Tahoe 2003-2006, Chevrolet Kodiak 2003-2009, Chevrolet Silverado/Classic 2003-2007, GMC Sierra/Classic 2003-2007, GMC TopKick 2003-2009, GMC Yukon/Denali/XL 2003-2006, Isuzu H-Series 2003-2008 1. Unsnap and remove dash bezel. 2. Remove (3) 9/32” screws and remove radio. Chevrolet Blazer 2002-2005, S-10/GMC Sonoma (with ISO DDIN radio) 2002-2004, Oldsmobile Bravada 1998-2001 1.
DASH DISASSEMBLY 95-2001 OR 99-2001 Chevrolet Cavalier 2000-2005 1. Open drivers door and remove fuse panel on end of dash. 6. Remove (1) Phillips screw from the defroster duct. 2. Open passenger door and remove panel on end of dash. 7. Remove the ductwork and (1) Phillips screw exposed. 3. Remove (1) Phillips screw from each side exposed. 8. Remove the dash pad and (3) Phillips screws exposed at the top of the radio trim bezel. 4. Remove (3) screws from top of glove box liner. 5.
DASH DISASSEMBLY 95-2001 OR 99-2001 Chevrolet Express Van 2001-2002, GMC Savanna 2001-2002 Chevrolet Express Van 2003-2007, GMC Savanna 2003-2007 1. Unsnap and remove small trim panel below steering column. (Figure A) 1. Remove (2) 10mm bolts from below knee bolster under steering column and remove panel. (Figure A) 2. Unsnap radio/climate/instrument panel. (Figure B) 3. Move shift lever to first gear position. 4. Rotate panel counterclockwise to lift over steering column and remove.
DASH DISASSEMBLY 95-2001 OR 99-2001 Chevrolet Impala 2000-2005 1. Unclip each side of the dash trim bezel (fuse access) and remove (1) Phillips screw exposed on each side. 2. Remove (2) Phillips screws under the instrument cluster. 3. Unclip the trim panel above the pedals. (It is not necessary to remove the panel it can be left hanging). Chevrolet Malibu 2001-2003, Chevrolet Malibu Classic 2004-2005 Chevrolet Monte Carlo 2000-2005 1. Unclip the trim panel above the pedals.
DASH DISASSEMBLY 95-2001 OR 99-2001 Chevrolet Trailblazer 2002-2009 Chevrolet Venture 2000, Oldsmobile Silhouette 2000, Pontiac Montana 2000 (Except SV6) 1. Remove (2) Phillips screws inside instrument cluster. 1. Remove the ashtray and (1) Phillips screw exposed in the ashtray cavity. 2. Remove (1) Phillips screw under climate controls to the left of the power outlet. 2. Remove (1) Phillips screw from the cigarette lighter compartment. 3.
DASH DISASSEMBLY 95-2001 OR 99-2001 Chevrolet Venture 2001-2005, Oldsmobile Silhouette 2001-2004 Pontiac Montana 2001-2005 (Except SV6) 1. Open cup holders and remove (2) Phillips 7mm screws. (Figure A) 2. Unsnap and remove dual power outlet assembly from lower storage. 3. Open lower storage door and remove (2) 7mm screws inside. (Figure A) (Figure B) (Figure C) (Figure D) 4. Models with DVD - Remove DVD player and remove (2) 7mm screws from behind and (2) 7mm screws near the floor. 5.
DASH DISASSEMBLY 95-2001 OR 99-2001 GMC Envoy 2002-2007, Isuzu Ascender 2003-2005, Oldsmobile Bravada 2002-2004, Buick Ranier 2004-2007 1. Remove (4) Phillips screws, (2) from left and (2) from right of carpeted panel. (Figure A) 2. Slide carpeted panel down and backwards to reveal (2) Phillips screws and remove. (Figure B) 3. Unsnap radio bezel and unplug cigarette lighter and accessories. (Figure C) 4. Remove (3) screws and remove radio.
DASH DISASSEMBLY 95-2001 OR 99-2001 Hummer H2 2003-2007 1. Open center console and remove (4) 9/32” screws from console box and remove box. (Figure A) 5. Remove (6) Phillips screws from top of center console. (Figure F) 9. Slide control assembly rearwards. (Figure F) 6. Remove (2) Phillips screws from 10. Remove (2) T-30 torx bolts from top 2.
DASH DISASSEMBLY 95-2001 OR 99-2001 Oldsmobile Achieva 1996-1998 Oldsmobile Alero 1999-2004 Oldsmobile Aurora 1995-2003 1. Open the glove box, press inward on the walls of the glove box liner and remove the liner. 1. Remove shift knob by using a small screwdriver to remove U-clip from front of shifter and pull upward. 1. Unclip the radio trim bezel and remove the bezel. (Figure A) 2. Remove (10) torx-head screws from the glove box location. 2. Unclip and remove shifter trim panel. 3.
DASH DISASSEMBLY 95-2001 OR 99-2001 Oldsmobile Cutlass 1997-1999, Oldsmobile Cutlass Supreme 1995-1997 Continue to Kit Assembly Oldsmobile Intrigue 1998-2002 1. Unclip the radio trim bezel and remove. 1. Open the center console storage compartment and remove (2) 9/32” hex-head screws exposed. 2. Remove (2) ) 9/32” hex-head screws securing the factory radio and disconnect the wiring. 1. Unclip the radio trim bezel and remove. (Figure A) 2.
DASH DISASSEMBLY 95-2001 OR 99-2001 Oldsmobile LSS 1996-1999 / Regency 1997-1998 Pontiac Aztec 2001-2005 Pontiac Bonneville 2000-2005 (CONT) 1. Open glove box and remove two-center trim bezels attached by screws. (Figure A) 1. Pull out cup holder inserts. 4. Depress the spring clips on each side of the factory head unit and remove. (Figure C) 2. Unsnap and remove radio trim bezel. (Figure A) 2. Remove (1) Phillips screw exposed inside bottom cup holder.
DASH DISASSEMBLY 95-2001 OR 99-2001 Pontiac Grand Am 2001-2005 Pontiac Sunfire 2000-2005 1. Unsnap and remove radio trim bezel. (Figure A) 1. Open the glove box and remove (2) Phillips screws exposed on the right edge of the radio trim bezel. 2. Remove (3) 9/32” screws from radio brackets and remove radio. (Figure A) 2. Unclip the bezel and remove. 3. Remove (2) 7mm hex-head screws securing the factory head unit and disconnect the wiring.
KIT ASSEMBLY ISO DDIN radio provision (95-2001): 1. Attach the radio brackets to the inside edge of the radio trim plate. (Figure A) 2. Slide the radio into the completed assembly, and then secure the radio to the assembly using the screws supplied with the radio. (Figure B) 3. Locate the factory wiring harness and antenna connector in the dash and complete all necessary connections to the radio. Metra recommends using the proper mating adapter from Metra and/or Axxess. Test the radio for proper operation.
INST-2001 I N S TA L L AT I O N I N S T R U C T I O N S IMPORTANT If you are having difficulties with the installation of this product, please call our Tech Support line at 1-800-253-TECH. Before doing so, look over the instructions a second time, and make sure the installation was performed exactly as the instructions are stated. Please have the vehicle apart and ready to perform troubleshooting steps before calling.