INSTALLATION INSTRUCTIONS FOR PART 99-9999 APPLICATIONS UNIVERSAL ISO STACK /DOUBLE DIN HEAD UNIT INSTALLATION KIT 99-9999 KIT FEATURES • ISO Stack and Double DIN Head Unit Provisions KIT COMPONENTS A) Faceplate • B) ISO Brackets A B TOOLS REQUIRED: • Phillips Screwdriver • Cutting Tool 1-800-221-0932 www.metraonline.
99-9999 TABLE OF CONTENTS Kit Assembly and Final Assembly - All Vehicles Double DIN Head Unit Mount Radio Provision . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1,2,3,4,5 ISO Stack Head Unit Mount Radio Provision KNOWLEDGE IS POWER Enhance your installation and fabrication skills by enrolling in the most recognized and respected mobile electronics school in our industry. Log onto www.installerinstitute.com or call 800-354-6782 for more information and take steps toward a better tomorrow.
99-9999 KIT AND FINAL ASSEMBLY ALL VEHICLES DOUBLE DIN HEAD UNITS: Disconnect the negative battery terminal to prevent an accidental short circuit. Continue to Final Assembly. ISO STACK HEAD UNITS: Disconnect the negative battery terminal to prevent an accidental short circuit. Mount the ISO Brackets to the ISO-Stack head units using the hardware supplied with the unit (see Fig. A). Fig.
99-9999 FINAL ASSEMBLY FINAL ASSEMBLY A (A) Strip wire ends back 1/2" B B) Twist ends together C) Solder D) Tape C D 1 Locate the factory wiring harness in the dash. Metra recommends using the proper mating adapter and making connections as shown. (Isolate and individually tape off the ends of any unused wires to prevent electrical short circuit.) 2 Re-connect the negative battery terminal and test the unit for proper operation.
99-9999 KIT AND FINAL ASSEMBLY ALL VEHICLES Slide the head unit(s) into the sub-dash and secure. Continue to Page 4.
99-9999 KIT AND FINAL ASSEMBLY ALL VEHICLES DOUBLE-DIN HEAD UNITS: Cut and remove the dividing rib in the center of the Faceplate ("A"). Place the Faceplate over the mounted head unit. Using the scored lines a a guide, cut the Faceplate to conform to the dash opening. ISO-STACK HEAD UNITS: Place the Faceplate over the mounted head unit. Using the scored lines a a guide, cut the Faceplate to conform to the dash opening. Continue to Page 5.
99-9999 KIT AND FINAL ASSEMBLY ALL VEHICLES Turn the Faceplate to the smooth side and place over the mounted head unit. Re-attach the trim bezel (this will secure the Faceplate). Re-connect the battery terminal and test the unit for proper operation.
99-9999 INSTRUCTIONS 1-800-221-0932 www.metraonline.com REV.