User Manual

ManualsBrandsMetra Electronics ManualsCar & Vehicle ElectronicsMetra Lower Dash Single DIN Installation Kit for 2003-2007 Honda Accord with Wire Harness

APPLICATIONS

METRA. The World’s best kits.

™

metraonline.com1-800-221-0932

REV. 11/25/2013 INST99-7862

CAUTION: Metra recommends disconnecting the

negative battery terminal before beginning any

installation. All accessories, switches, and especially

air bag indicator lights must be plugged in before

reconnecting the battery or cycling the ignition.

NOTE: Refer to the instructions included with the

aftermarket radio.

Table of Contents

INSTALLATION INSTRUCTIONS FOR PART 99-7862

• DIN radio provision with pocket

• ISO DIN radio provision with pocket

• A) Radio Housing • B) ISO Brackets • C) ISO Trim Plate • D) Radio “T” Harness

KIT FEATURES

KIT COMPONENTS

WIRING & ANTENNA CONNECTIONS (sold separately)

Wiring Harness: • Harness Included

Antenna Adapter: • Not required

• Panel removal tool • Phillips screwdriver

• Socket Wrench

TOOLS REQUIRED

Honda Accord 2003-2007

99-7862

B C D

Dash Disassembly

– Honda Accord 2003-2007 .................................... 2

Kit Assembly

– DIN radio provision with pocket ............................ 3

– ISO DIN radio provision with pocket ...................... 3

Summary of content (4 pages)

PAGE 1
INSTALLATION INSTRUCTIONS FOR PART 99-7862 APPLICATIONS Table of Contents Honda Accord 2003-2007 99-7862 Dash Disassembly – Honda Accord 2003-2007 .................................... 2 Kit Assembly – DIN radio provision with pocket ............................ 3 KIT FEATURES • DIN radio provision with pocket • ISO DIN radio provision with pocket – ISO DIN radio provision with pocket......................
PAGE 2
99-7862 Dash Disassembly 5. Remove (2) Phillips screws facing up under radio/climate control assembly. (Figure E) 1. Unsnap and remove shift lever trim ring. (Figure A) 2. Unsnap coin tray/ashtray from assembly and remove. The rubber cover may come out first but entire assembly must be removed to access screws below. (Figure B) 3. Remove (2) Phillips screws from under coin tray/ashtray and remove entire assembly. (Figure C) 6.
PAGE 3
99-7862 Kit Assembly DIN radio provision ISO DIN radio provision 1. Snap the DIN cage into the radio housing and secure by bending the metal locking tabs down. (Figure A) 1. Mount the ISO brackets to the radio with the screws supplied with the radio. (Figure A) 2. Slide the radio into the radio opening until the side clips engage. Snap the trim plate into the radio housing. (Figure B) 2. Slide the aftermarket radio into the cage and secure. (Figure B) 3.
PAGE 4
INSTALLATION INSTRUCTIONS FOR PART 99-7862 Wiring the 99-7862 Metra/EIA Wiring Code 12V Ignition/Acc........... Red 12V Batt/Memory..... Yellow Ground ......................Black Power Antenna ........... Blue Amp Turn-On .....Blue/White Amp Ground ....Black/White Illumination ............. Orange Dimmer ........ Orange/White Right Front (+) ............ Gray Right Front (-) ...Gray/ Black Left Front (+) .............White Left Front (-) ....White/Black Right Rear (+) ............