Installation Guide

Methven warrants this product against manufacturing defects and that it is suitable for use

under the general operating conditions speciﬁed in this instruction sheet. However, regional

regulations apply and may aﬀect your warranty. Please refer to www.methven.com or call

customer service for full details.

New Zealand

0800 804 222

Australia

1300 638 483

0800 195 1602

www.methven.com

Never use abrasives or abrasive cleaning agents to clean this product. Clean regularly with

contamination free warm soapy water and a damp soft cloth.

Clean ﬁlter washer located in the ball joint periodically.

Care and Cleaning:

If shower performance is compromised by the build-up of lime-scale, clean by using a soft

toothbrush and gently scrubbing along the spray slot under running water.

439922

ISSUE A

Technical Speciﬁcations:

Operating Pressure:

Min: 100kPa/1bar

Max: 500kPa/5bar*

Optimum: 150kPa/1.5bar - 500kPa/5bar

Operating Temperature:

Hot: Max 70°C*

Cold: Min 5°C

Inlet Connections:

All ½" BSP

* Regional speciﬁc regulations apply.

Please refer to your warranty statement at

www.methven.com

AURAJET™ WALL SHOWER

ON SHORT ARM

Installation Guide

PAGE 1
Care and Cleaning: Never use abrasives or abrasive cleaning agents to clean this product. Clean regularly with contamination free warm soapy water and a damp soft cloth. Clean filter washer located in the ball joint periodically. AURAJET™ WALL SHOWER ON SHORT ARM Installation Guide Technical Specifications: Operating Pressure: Min: 100kPa/1bar Max: 500kPa/5bar* Optimum: 150kPa/1.
PAGE 2
IMPORTANT: Please read all of the instructions before installation. IMPORTANT: Before you begin, turn off the water supply. m General: Step 1 • Methven recommends this product is installed by a licensed plumber in compliance with all relevant regional regulations. • After installation all connections must be checked for leaks. • All outlets used primarily for personal hygiene shall deliver water at a safe temperature as per regional regulations.