MODEL: AL-Q0105 EASY-SET SCAFFOLD TOWER™ OPERATIONAL SAFETY AND ASSEMBLY INSTRUCTIONS READ THESE INSTRUCTIONS CAREFULLY BEFORE USING THIS PRODUCT. KEEP THIS MANUAL HANDY FOR FUTURE REFERENCE. Customer Service 1 800 363-7587 IN-Q0105-US-01 Picture may differ from actual product.
READ BEFORE BEGINNING ASSEMBLY. FAILURE TO UNDERSTAND AND FOLLOW ALL SAFETY RULES AND ASSEMBLY INSTRUCTIONS COULD RESULT IN SERIOUS INJURY OR DEATH. METAL CONDUCTS ELECTRICITY: Do not use this equipment where contact may be made with power lines or other live electrical circuits. DO NOT OVERLOAD: Scaffolding maximum load: 800 lb (363 kg). Platform: 25 lb/sq. ft. (122 kg/m2) ASSEMBLY PROCESS 1. Preparation • • • • • Locate the tower, ensuring ground is level. Unlock the interlock pins on all frames.
USAGE ADVICE • • • • • • • • • • • • • • • • We recommend a minimum of two people to assemble, dismantle and move the platform tower. Check that all components are on site and in good working order. Ensure that the assembly location is checked to prevent hazards during assembly, dismantling or moving and while working on the tower. Particular attention should be given to the ground condition, whether level or sloping, obstructions and wind conditions.
STABILISERS are to be used, when specified, to guarantee the structural stability of the tower. Fig.2 Fig.3 Fig.4 STABILISERS Lightly tighten the upper clamps above the sixth rung on each corner post. Position the lower clamp above the bottom rung. Ensure the lower arm is as horizontal as possible. Position the stabilisers so that the footpads are approximately equidistant from each other, as shown in Fig.2. Adjust the outrigger and reposition the clamps as required to make contact with the ground.
SET-UP TRADE TOWER - 1.
SET-UP TRADE TOWER - 1.8m 9 10 11 12 WWW.METALTECH.CO 1 800 363-7587 LAVAL, QUEBEC, CANADA H7L 3N6 Metaltech is a registered trademark of Metaltech-Omega inc.
