User's Manual

HWM6505-ZZ
High Power ZigBee Module User Guide
Introduction
WHM65050-ZZ is a low power consumption ZigBee module optimized for embedded
applications. It can be installed on PCB board and help OEMs to add wireless capability to
electronic devices.
Features
Built-in Antenna
Ultra-low current consumption in sleep mode
3.3 V power supply only
Outstanding communication range
Mini size for easy implementation
Specification
ZigBee RF Characteristic
RF Protocol: IEEE 802.15.4
RF frequency: 2405MHz~2480MHz
Channel Bandwidth: 5MHz
ZigBee Encryption: AES 128bits
Dimension
L29 x W17.78 mm
Temperature
Operating: -10ºC ~ 50ºC (32ºF ~ 132ºF)
Storage: -10ºC ~ 60ºC (-4ºF ~ 158ºF)
Operating Humidity
5% ~ 95% Non-Condensing
Compliance
FCC subpart 15B and subpart 15C
Canadian ICES-003
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
This device and its antenna(s) must not be co-located or operation in conjunction with any
other antenna or transmitter.
IMPORTANT NOTE
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance
20cm between the radiator & your body.
IMPORTANT NOTE
This module is intended for OEM integrator only and limited to inserted to similar host
device (Brand: Metalligence and Model: HWM6505-ZZ). The OEM integrator is still
responsible for the FCC compliance requirement of the end product, which integrates this
module.
20cm minimum distance has to be able to be maintained between the antenna and the
users for the host this module is integrated into. Under such configuration, the FCC
radiation exposure limits set forth for an population/uncontrolled environment can be
satisfied.
Any changes or modifications not expressly approved by the manufacturer could void the
user's authority to operate this equipment.
which is battery powered host
deivces and has a plastic housing without any metal shielding.The OEM integrator is still
responsible for the IC compliance requirement of the end product, which integrates this module.

Summary of content (2 pages)