User's Manual

T.2 INSTALLATION MANUAL

5040331600

KIT COMPOSITION

INSTALLATION

Power Supply: ..................................................................................12Vdc (9V-14V)

Working temperature: ..........................................................from -30°C to +80°C

IP: .....................................................................................................................................40

Application classi cation: ...........................................passenger compartment

TECHNICAL SPECIFICATIONS

WARNINGS

• ALL INSTALLATION OPERATIONS MUST BE CARRIED OUT WITH THE MOTOR OFF.

• Before starting installation, detect the OBD port location referring to the use and maintenance manual of the

vehicle.

• If the OBD connector should be used for other purpose, such as maintenance, remove T2 and, after tempora-

ry operation, reconnect the T2 to OBD connector.

• Strictly comply with operations indicated in this manual.

• Installation sta are not authorised to remove warranty seals and/or access the inside of the product.

• The device must be connected to OBD port on board to the vehicle, provided with protectec power supply

by means a 5 A fuse maxiumum activation current.

• The manufacturer assumes no responsibility for damages caused to property and/or people, caused

by the incorrect installation of the product.

TELEMATIC CONTROL UNIT

2c2b

OBD PORT

By using user manual of the vehicle  nd

the OBD connector on your car.

Typically OBD plug can be located:

• near the breaks unit

• near the fuse box

• under the dashboard

• in the middle console

Plug the connector into the vehi-

cle’s OBD.

Lock the Secondary Lock to se-

cure the device.

Check that the device is fully

connected and does not unlock.

PAGE 1
5040331600 T.2 INSTALLATION MANUAL KIT COMPOSITION EN TECHNICAL SPECIFICATIONS Power Supply: ..................................................................................12Vdc (9V-14V) Working temperature: ..........................................................from -30°C to +80°C IP: .....................................................................................................................................40 Application classification: ...........................................
PAGE 2
REMOVING THE PRODUCT Unlock the Secondary Lock to release the device. Remove the device. 3a 3b STANDARDS APPLICABLE TO THE VEHICLE The instructions in this manual do not refer to specific vehicle models but apply to all vehicles in general. Any information provided by Meta System regarding a type (model) of vehicle is to be considered purely indicative.