User's Manual

ManualsBrandsMETA System ManualsElectronicsTelematic Tracking System

SAT RC 09

INSTALLATION MANUAL

CAUTION

- Only carry out the operations described in this manual.

- The installer is not authorized to remove the warranty seals or to access the interior parts of the products or accessories.

- The installer is not authorized to modify and/or adapt the product or the relative accessories.

- The manufacturer declines all liability for damage to persons and/or property caused by incorrect installation of the product.

TECHNICAL SPECIFICATIONS

Dimensions and weight:....................................................................................104X75X27, 168g

Power supply voltage:................................................................................................12 VDC

Temperature:..........................................................................................................-25º+70ºC

Power input*:.............................................................................................................<2mA

*With the peripheral device connected, the GPS off, Sat Programmer disconnected and the internal

buffer battery charged.

Maximum current:.............................................................................................................<210mA

DISCONNECT THE VEHICLE’S BATTERY

GROUND

BATTERY

POSITIVE

(+12V)

IGNITION

KEY POSITIVE

(+15)

GSM

ANTENNA

PRESS

TO RELEASE

GPS

ANTENNA

Release and position the lever

as shown in the figure before

connecting the 18-pin loose

connector to the terminal.

CONNECTOR

CONNECTIONS

Lock the connector to the terminal by positioning the lever

as shown in the figure.

Connect the connectors

to the terminal

PHASE

Fig.2

Fig.3

Fig.4

WARNING: make sure that the connector is inserted

and locked to the terminal in the correct way.

* : MANDATORY

5040273800

+15

SAT

PROGRAMMER

+12

GND

Fig.1

DARK BLUE

MAROON

GENERAL LAYOUT

See pic. 5

Summary of content (4 pages)

PAGE 1
5040273800 EN SAT RC 09 INSTALLATION MANUAL CAUTION - Only carry out the operations described in this manual. - The installer is not authorized to remove the warranty seals or to access the interior parts of the products or accessories. - The installer is not authorized to modify and/or adapt the product or the relative accessories. - The manufacturer declines all liability for damage to persons and/or property caused by incorrect installation of the product.
PAGE 2
CONNECTION CRASH SENSOR CLICK! CAUTION! CHECK THE CORRECT CONNECTION CLICK! Fig.5 HOW TO POSITION THE DEVICE • Position the device in a concealed part of the vehicle, inside the passenger compartment • To allow the diagnosis and testing operations to be carried out without difficulty, it is essential to install the device in a position where it can be easily reached with the cable of the Sat programmer. • Do not install the device under a mat, where it could be trodden on or crushed by a load.
PAGE 3
HOW TO CONNECT THE GPS ANTENNA OK OK OK IT MUST NOT BE VISIBLE OR EASILY ACCESSIBLE FROM THE OUTSIDE HOW TO FIX THE ANTENNA: - ON METAL PARTS WITHOUT THE USE OF THE DOUBLE-SIDED ADHESIVE MATERIAL (THE ANTENNA IS MAGNETIC) - ON PLASTIC PARTS USING THE DOUBLE-SIDED ADHESIVE MATERIAL SUPPLIED IN THE KIT OK GPS ANTENNA CAREFULLY CLEAN THE FIXING SURFACE 90° NO ONCE YOU HAVE CHOSEN THE POSITION FOR THE ANTENNA, MAKE SURE THAT THE RECEPTION IS GOOD BEFORE FIXING IT IN PLACE: - DRIVE THE VEHICLE TO AN O
PAGE 4
R&TTE Declara t io n O f C o n fo r m it y ( D o C ) 0470 We: Meta System S.p.A. with the address: Via Majakovskij 10 b/c/d/e 42124 Reggio Emilia –Italy Declare Under own responsibility that the product: SAT RC 09 To which this declaration relates is in conformity with the essential requirements and other relevant requirements of the R&TTE Directive (1999/5/EC). This product is in conformity with the following standards - Health & Safety (art.3.1) EMC (art.3.