SB2165 INSTRUCTION MANUAL PLEASE READ BEFORE OPERATING THIS EQUIPMENT
WARNING TO PREVENT FIRE OF SHOCK HAZARD, DO NOT USE THIS PLUG WITH AN EXTENSION CORD, RECEPTACLE OR OTHER OUTLET UNLESS THE BLADES CAN BE FULLY INSERTED TO PREVENT BLADE EXPOSURE. TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. The Caution Marking is located at the back enclosure of the apparatus. The Rating plate is located at the back enclosure of the apparatus IMPORTANT SAFETY INSTRUCTIONS 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. Read these instructions.
15. This appliance shall not be exposed to dripping or splashing water and that no object filled with liquids such as vases shall be placed on the apparatus. 16. Do not overload wall outlet. Use only power source as indicated. 17. Use replacement part as specified by the manufacturer. 18. Upon completion of any service or repairs to this product, ask the service technician to perform safety checks. 19.
COMPLIANCE WITH FCC REGULATIONS FCC ID: 2AYB76962165 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B Digital Device, pursuant to Part 15 of the FCC Rules.
Caution: - Any use of the controls or performing any of the procedures in a way other than those specified herein may result in hazardous radiation exposure. - This unit should not be adjusted or repaired by anyone except qualified service personnel. ON PLACEMENT Do not use the unit in places which are extremely hot, cold, dusty or humid. Place the unit on a flat and even surface.
DEAR STUDEBAKER® CUSTOMER Selecting fine audio equipment such as the unit you've just purchased is only the start of your musical enjoyment. Now it's time to consider how you can maximize the fun and excitement your equipment offers. This manufacturer and the Electronic Industries Association's Consumer Electronics Group want you to get the most out of your equipment by playing it at a safe level.
LOCATION OF CONTROLS 1 FM ST.
POWER SOURCE This unit can be operated using either AC power, the built-in Li-Polymer rechargeable battery. AC POWER OPERATION An AC-DC Adaptor with the output of DC 15V, 4A (included) is required for operating the main unit when using AC power mode. To connect the AC-DC Adaptor to the unit and 120V~ 60Hz AC Outlet: 1. Firmly and securely insert the DC plug of the adaptor into the DC Jack on the back of the unit. 2. Plug the AC Adaptor plug into the 120V AC outlet.
CHARGING INSTRUCTIONS CHARGING THE BATTERY WITH THE INCLUDED AC ADAPTOR 1. Charge the built-in Lithium battery a minimum of 5 hours prior to first use. Firmly and securely insert the DC plug of the adaptor into the DC Jack on the back of the unit. 2. Plug the AC Adaptor plug into the 120V AC outlet. Connecting this system to any other power source may cause damage to the system. 3.
TIPS FOR BEST RADIO RECEPTION FM - If a stereo broadcast program is being received, the FM STEREO INDICATOR will light. During FM Stereo reception, always keep the FM TELESCOPIC ANTENNA fully extended for best performance. However, if FM reception is weak, try repositioning the unit near an open window until you get the best reception. CD OPERATION PLEASE READ THIS IMPORTANT INFORMATION: CD mechanisms used in devices like this are designed to fully read all commercial CDs.
To Cancel Repeat Function: Press the REPEAT BUTTON until REPEAT indicator goes off from LED display. PROGRAM OPERATION This function allows the tracks to be played in a programmed sequence. NOTE: Programs can only be set in STOP mode. 1. In CD stop mode, press REPEAT/PROGRAM button, the PROGRAM indicator will light flash and Program Number “P01” will show on LED display. or button to select the desired track. The track number “1” (001 2.
Play/Pause Control button, music playback will be paused and the To temporarily stop playing, press the PLAY/PAUSE indicator will be blinking. Press the button again to resume playback. Stop playback button on the unit. The total number of tracks/files on the To stop playback, press the STOP USB flash-drive will be shown on the LED display. Skip track During playback, press the SKIP backward or next track/file.
BLUETOOTH OPERATION PAIRING A SMARTPHONE OR BLUETOOTH ENABLED DEVICE The Bluetooth feature enables you to stream and play the digital music on your Bluetooth enabled device to your unit. 1. POWER on the unit, slide the FUNCTION switch to Bluetooth position, the Bluetooth indicator will flash. 2. The unit will start in auto connection mode and search for a previously paired device that is active and in range (30 feet/10 meters).
RE-LINKING TO A SMARTPHONE OR BLUETOOTH ENABLED DEVICE Even if your smartphone or Bluetooth device is already paired with the SB2165 and with both Bluetooth functions turned on, they can become unlinked at some point due to intentional manual disconnection or undesirable external signal interferences or over-range for more than 10 seconds. If this happens, the unit will emit two short beeps. You can re-link them and resume play by: 1.
AUX IN OPERATION You can play other music sources (iPod, MP3 or other digital audio players) through the speakers of the unit by connecting the AUX IN JACK to your external player’s audio out jack or headphone jack. 1. Plug one end of a 3.5mm audio cable (not included) into the AUX IN JACK and the other end of the cable to the headphone jack of your digital audio player. 2. Slide the FUNCTION switch to the AUX IN position. 3. Turn on and start playing the external device you plugged into the AUX IN JACK. 4.
5. Keep your unit away from heating appliances and sources of electrical noise such as fluorescent lamps or motors. 6. If drop-outs or interruptions occur in the music during CD play, or if the CD fails to play at all, its bottom surface may require cleaning. Before playing, wipe the disc from the center outwards with a good soft cleaning cloth. CLEANING THE UNIT To prevent fire or shock hazard, disconnect your unit from the AC power source when cleaning.
CD player will not play Unit not in CD function mode. CD is installed incorrectly. CD skips while playing Intermittent sound from CD Player If the CD is self-compiled, the media used may not be compatible with the player. Disc is dirty or scratched. Dirty or defective disc. Dirty pick up lens. Sound is distorted Player is subject to excessive shock or vibration. Volume level is set too high. Sound source is distorted. Unit gets warm after extended play at high volume This is normal.