Horus Release Notes Horus & Hapi Release Notes www.merging.
Horus Release Notes HORUS & HAPI FIRMWARE Make sure that you are running the latest certified firmware: http://www.merging.com/products/horus/downloads Verify your Horus or Hapi firmware version by going to the Horus or Hapi Setup menu and open the System info page to verify the firmware version installed. Refer to the Horus or Hapi User Manual Firmware Update section in order to proceed with a Firmware update. Note: There are two types of Horus & Hapi updates possible.
Horus Release Notes New: Support for DA run7 modules (requires firmware v3.0 and above) Improvement: Firmware version identification improved (under info page) Improvement. Manual override Fan OFF option on Horus to halt Fan during recordings Improvement. Web Access: Pre Amps and Meters pages now include VU Metering Improvement: Auto sampling rate option mode (under Format page) Fixed. CRC Error inaccurately displayed Fixed. FAN Hysteresis doesn't work properly Fixed. Hapi.
Horus Release Notes Sharp roll-off filter: Offers a flat frequency response up to 22kHz, within 0.2dB, which has the tradeoff of 36 samples latency. This mode was and still is the default one. Slow roll-off filter: Offers a low latency of 9 samples, with the tradeoff of a gentle frequency response attenuation starting around 16kHz and reaching 2.
Horus Release Notes Improvement : Limiter added to avoid noise when overloading input in DSD Fixed. Horus monitor jack provides the same channel on both outputs (8FS only) Fixed. Phase invert now working in DSD Fixed in Firmware version 20084: Improvement: DSD256 noise floor improvement Improvement: DSD256 removed DC offset Improvement: DSD64 and DSD128 support Improvement: Added support for 720p 23.
Horus Release Notes Fixed in Firmware version 18725: Warning: Users updating from a firmware < 18491 (RC1) will need to perform a second Shutdown of the Horus after the Firmware update (in order to initialize correctly the AD and DA modules) Improvement: Metering support on the Web Access Page (see Horus user manual for details) Improvement: The Horus TFT Meter page will gray out all inactive MADI leds Improvement: WordClock output now supported at all sampling rates Improvement: Lock mechanism imp
Horus Release Notes Fixed. Larger Wordclock range of deviation allowing some highly deviating clock sources (more than 100 ppm) to lock correctly Fixed. RAVENNA small mute on random streams Fixed. Some Horus were always rebooting in Maintenance Mode or hanging on “starting application” screen Fixed. Limit preamp fader moves to the group min and max for all members of the group Fixed. Horus being muted at times (needing extra reboot).
Horus Release Notes Fixed: WordClock support with phase alignment Fixed: The D/A Small fade in apply on source is now removed Fixed: TFT splashscreen option (Setup>Advanced) Fixed: Web Control access: PreAmps Metering range for Mics and Line Fixed: Web Control access: PreAmps Mic Pading range indication Fixed: Web Control access: PreAmps Mic/Line Coherency and relative group Gains support Fixed: Web Control access: Horus User Manual embedded (now working with Chrome) Fixed in Firmware versi
Horus Release Notes HORUS & HAPI TROUBLESHOOTING Rollback Firmware Users that need to rollback to a previous firmware version can do so. Firmware v23783 goes with Maintenance Mode v29 and does not support Maintenance Mode v23. Firmware v23165 and below go with Maintenance Mode v23 or Maintenance Mode v29 Note: What might occur if your Firmware version is not in front of the Maintenance Mode version is that the Horus might always start up in Maintenance mode.