Assembly Instruction

266285 - BJ 57IN SNOWMAN WITH SNOWFLAKES

Connect the hook (located on

the topper body) to make the

whole body steady.

1. Take the snowman out of the package .

Assemble the two half parts of the bottom

body by inserting tubes or hook through

the circles on each side as shown in the

picture above .

2. Assemble the snowman’s upper body onto

the bottom one .

3. Put the snowman’s hat and arms

on the body .

4. Wrap the light chain on the metal wire and install

the snowflakes one by one as shown, then connect

the end plug with the connector of the body lights.

6. Assembly is now complete . if using outdoors on a

lawn , secure the snowman by inserting the 4 lawn

stakes through the supports and into the soil.

5. Install the metal wire on snowman’s hand

and put the scarf around the neck.

PAGE 1
266285 - BJ 57IN SNOWMAN WITH SNOWFLAKES Assembly Instruction Connect the hook (located on the topper body) to make the whole body steady. 1. Take the snowman out of the package . Assemble the two half parts of the bottom body by inserting tubes or hook through the circles on each side as shown in the picture above . 4. Wrap the light chain on the metal wire and install the snowflakes one by one as shown, then connect the end plug with the connector of the body lights. 2.
PAGE 2
IMPORTANT SAFETY INSTRUCTIONS When using electrical products, basic precautions should always be practiced including the following: 1. READ AND FOLLOW ALL SAFETY INSTRUCTIONS. 2. Read and follow all instructions that are on the product or provided with the product. 3. Do not use an extension cord. 4. Reference the National Electrical Code , ANSI/NFPA 70, specifically for the installation of wiring and clearances from power and lighting conductors . 5.