Instruction Manual

ManualsBrandsMEIYUME ManualsElectronicsLXIII NOUVEAU DISPLAY LOCKER LUMINEUX

Table Of Contents

Step 1: Take out the locker, identify all switches,

connection points and indicators.

Reset Button

Charging

Connection to

Charging Dock

DC Jack

On/Off Switch

Indicator for Battery

status: Red & Green

Indicator for

Door:Red & Blue

Detachable Logo Plate

& IC Card Sensor

Step 2: Switch on the product, place the IC card to the sensor

(logo plate)until it beeps, the doors will open.

Step 3: Press the button on the bottle neck holder to release the

lock,place the bottle on the lighting patch. Once bottle is

placed, the lighting patch will light up. Close the bottle

neck holder to secure the bottle

Step 4: Place the IC card to the sensor (logo plate) until it beeps,

the doors will close and beep again to indicate it is locked.

Doors Closed

LXIII NOUVEAU DISPLAY LOCKER LUMINEUX

Instruction Manual

Switch on the locker, logo plate and back panel will light up,

battery indicator will be flashing. If not, please recharge the product.

Remarks: Once the locker is switched on, opening and closing door can be controlled by IC card, until the product is switched off!

Put the bottle cap into the holder and

press down to its desired position.

Three shifts of

light-dark controller

Summary of content (5 pages)

PAGE 1
LXIII NOUVEAU DISPLAY LOCKER LUMINEUX Instruction Manual Switch on the locker, logo plate and back panel will light up, battery indicator will be flashing. If not, please recharge the product. Indicator for Door:Red & Blue Detachable Logo Plate & IC Card Sensor Indicator for Battery status: Red & Green Reset Button Three shifts of light-dark controller Charging Connection to Charging Dock DC Jack On/Off Switch Step 1: Take out the locker, identify all switches, connection points and indicators.
PAGE 2
LXIII NOUVEAU DISPLAY LOCKER LUMINEUX How to pair IC card with locker Make sure doors are closed before pressing RESET button When pairing the IC card with Glorifier, make sure to maintain the card still to avoid mis-pairing. RESET Button Step 1: Press down RESET button for 3 seconds until you hear a beep, and you can see red / blue light are flashing, and the backlit panel area is at its brightest.
PAGE 3
LXIII NOUVEAU DISPLAY LOCKER LUMINEUX How to install Charging Dock / How to recharge product. How to install Charging Dock Make sure charging connection is facing front before fixing it onto the shelf. Shelf to be in MDF Step 1: Unpack the charging dock and screws enclosed. Step 2: Fix the charging dock onto the shelf with screws. How to charge the locker The product will be covered by the Warranty if it is only used with the delivered charger.
PAGE 4
LXIII NOUVEAU DISPLAY LOCKER LUMINEUX How to dismantle Switch off power before dismantling the product 8 screws Step 1: Unscrew the 3 screws and remove the back panel. Step 2: Unscrew all 8 screws indicated in red. Remove the back cover and apply the W a r n i n g lubricant (e.g. WD-40 or other brand of equivalent lubricant ) on rail / gears in case The light source of this luminaire is not replaceable; when the light of the door opening is not smooth or blocked.
PAGE 5
LXIII NOUVEAU DISPLAY LOCKER LUMINEUX This device complies with part 15 of the FCC Rules.Operation is subject to the following two conditions: (1)this device may not cause harmful interference,and (2)this device must accept any interferencereceived,including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.