User's Manual
NOTE:
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
This equipment has been tested and found to comply with limits for a Class B
digital-device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instruction, may cause
harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
1, Reorient or relocate the receiving antenna.
2, Increase the separation between the equipment and receiver.
3, Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
4, Consult the dealer or an experienced radio / TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
INSTRUCTION MANUALS
As with all electrical products, precautions should be observed during handling
and use to reduce the risk of electric shock.
The charger be periodically examined for conditions that may result in the risk of
fire, electric shock, or injury to persons and that, in an event such conditions, the
charger should not be used until properly repaired.
1.
Our product, item no MSD0902 Super Rolling Car, contains“ CAR
BODY”,“TRANSMITTER”
2. Put a 9.0v alkaline battery into the transmitter and 4 X1.5V AA batteries
into the car body
3. Pull out the antenna, and turn on the power switch, then you can use the
controllers to move the car.
4.
Single movement: if you press the left switch of the controller to “GO”, the
car goes forward; and to “ BACK ”,the car moves in reverse. if you press the
switch at the right to “STEERING” and move it to to the left or to the
right ,the car turns left or right.
5. Advanced movement:
A. If you press the left switch to “ GO ” and, at the same time ,the right
switch to “ ROLL ”, the car goes forward, accelerating, rolling, or
turning left or right.
B. If you press the left switch to “ BACK ”,and the right switch to
“ ROLL ”the car reverses, accelerating, rolling, or turning left or right.
6. The charger can be used for more than 20 minutes after 4 or 6 hours charging.
to take the battery out, press the red button.