EX-G016 2x8 HDMI 1.
Safety and Notice The EX-G016 2x8 HDMI 1.3 over Single CAT5 Cascading Distribution Amplifier has been tested for conformance to safety regulations and requirements, and has been certified for international use. However, like all electronic equipments, the EX-G016 should be used with care. Please read and follow the safety instructions to protect yourself from possible injury and to minimize the risk of damage to the unit. z Follow all instructions and warnings marked on this unit.
Features z State-of-the-art Silicon Image (founder of HDMI) chipset embedded for upmost compatibility and reliability z HDMI 1.
Specifications & Package Contents Model Name Technical Role of usage HDMI compliance HDCP compliance Video bandwidth Video support Transmission Audio support Equalization Input TMDS signal Input DDC signal ESD protection [EX-G016 / EX-G076A] PCB stack-up Input Output HDMI connector RJ-45 connector DIP switch Mechanical Housing EX-G016 EX-G076A EX-G076B 2x8 distribution amplifier Transmitter [TX] Receiver [long range RX] Receiver [short range RX] HDMI 1.3c 0Yes Single-link 340MHz [10.
Panel Descriptions Front Panel 3 1 2 1. 2. 3. 4. 4 1.2a/1.3a: Output format LED indicator [Green: HDMI 1.3 / Red: HDMI 1.2] Format Sel: Push button for HDMI output format selection IN 1/IN 2: Input LED indicator [Green: HDMI input / Red: RJ-45 input] IN Sel: Push button for input HDMI source selection Rear Panel 5 6 7 8 9 10 11 12 5. DIP Switch: EDID/Audio setting [see following section] 6. EQ: Rotary control for equalizer setting [see following section] 7.
DIP Switch Pin#1 Position OFF [©] ON [ª] Pin#2 Position OFF [©] ON [ª] EDID Mode Use Default EDID Use learned 1 EDID Audio Mode 7.1 2 Channel Stereo Note 1 2 Set pin#1-ON[ª] first and then connect the HDMI Input to HDMI display thru HDMI cable. Wait for 20 seconds. The Recording Procedure will be finish. If you want to learn the EDID for another equipped display, you must set pin#1-OFF[©] and repeat the procedure.
Hardware Installation 1. Connect Cat-5e cable if using any Cat-5e HDMI video transmitter as cascading source 2. Connect HDMI input to HDMI compliant sources (such as a Blu-ray Disc player) 3. Connect all HDMI outputs to the HDMI displays 4. Connect RJ-45 output to HDMI over CAT5 receiver through Cat-5e cable 5. Plug in 5V 4A DC power supply. 6. Power on the EX-G016 7. Power on the HDMI displays. 8. Power on the HDMI source(s).
Notice 1. If the DVI or HDMI device requires the EDID information, please use EDID Reader/Writer to retrieve and provide DVI/HDMI EDID information. 2. All HDMI over CAT5 transmission distances are measured using Belden CAT5e 125MHz LAN cable and ASTRODESIGN Video Signal Generator VG-859C. 3. The transmission length is largely affected by the type of LAN cables, the type of HDMI sources, and the type of HDMI display.
Limited Warranty The SELLER warrants the EX-G016 2x8 HDMI 1.3 over Single CAT5 Cascading Distribution Amplifier to be free from defects in the material and workmanship for 1 year from the date of purchase from the SELLER or an authorized dealer.