Installation Instructions

Areas of application:
Remote control switches,alarm systems, , remote control door locks, remote control electric
shutter doors and Windows, water pump control, industrial control products, etc.;
technical parameters:
Working voltage: DC12V
Working frequency: 433.92 MHz
Standby current: 0MA
Working current: > 80MA
Encoding Type: fixed code (2264) and learning code (EV1527)
Transmission distance: > 2000 m (open area sensitivity more than 103 dBm)
Output power: 2000 m (18 DBM);
Transfer rate: < 10 KBPS
Modulation mode: ASK (amplitude modulation)
Working temperature: - 10 ℃ ~ + 70 ℃
Size:136 * 42.2 * 25 mm
* Tips: 1. This series of remote wireless remote control with 1/2/3/4/6/8/12 key optional;
2.With the power switch, remote control can turn off the power save electricity when not
in use.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two co
nditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
The device has been evaluated to meet general RF exposure requirement. The device can be us
ed in portable exposure condition without restriction.
Changes or modifications to this unit not expressly approved by the party responsible for complia
nce could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in accordance with the in
structions, may cause harmful interference to radio communications. However, there is no guarant
ee that interference will not occur in a particular installation. If this equipment does cause harmfu
l interference to radio or television reception, which can be determined by turning the equipment
off and
on, the user is encouraged to try to correct the interference by one or more of the following me
asures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
- Consult the dealer or an experienced radio/ TV technician for help.