STEREO WIRELESS BLUETOOTH HEADPHONES model: AF62 USER MANUAL part of the series
EN TABLE OF CONTENTS Product Overview Charging Powering On and Off Pairing with Bluetooth® Devices iPhone®, iPad®, and iPod touch® Android™ Phones and Tablets Computers and Laptops Pairing with Bluetooth devices using NFC Connecting to Paired Devices Using the Matrix Headphones Adjusting Volume Controlling Phone Calls Controlling Media Playback Additional Functionality Using as a Wired Headphone Safety and Care Specifications Troubleshooting MEElectronics and its logo are registered trademarks of S2E, Inc
PRODUCT OVERVIEW EN
CHARGING *** You must completely charge the headset before the first use *** Connect the USB charging cable to any powered USB port and to the USB jack on the right ear cup. The red LED indicator will light solid while charging. Charge time is typically 3-6 hours for the first charge and 2-3 hours for subsequent charges. When the battery is fully charged the bright red LED indicator will turn off. Note: Bluetooth will function when the unit is charging, but leaving the Matrix on can increase charge time.
PAIRING WITH BLUETOOTH® DEVICES *** It is only necessary to pair your Matrix once with each device *** a) Open the Bluetooth menu* on the device you wish to pair. Some devices require you to select “search for devices” or “add new devices” in order to create a Bluetooth pairing. b) Make sure the Matrix is off and within 1 meter of your device. Initiate pairing mode by pressing the Power button for 6 seconds, until you hear “ready to pair, turn on Bluetooth, the pin code is 0000”.
PAIRING WITH BLUETOOTH DEVICES USING NFC Note: When the volume reaches the minimum or maximum level there will be two short tones. a) Put the Matrix in pairing mode b) Place the NFC-compatible device against the left ear cup of the Matrix until pairing is complete.
USING THE MATRIX HEADPHONES (Continued) Controlling Phone Calls Status Answer a call Single press the Power button End a call Single press the Power button Answer new call and place the current call on hold Single press the Power button Switch active calls Press and hold the Power button for 2 seconds. There will be a single tone to indicate the calls have been switched.
USING THE MATRIX HEADPHONES (Continued) Additional Functionality Action / Status Activate voice command / dialing1 1 Button Function Single press the Power button Sounds Short tone Not all devices support this functionality. For more information, refer to the user manual for your device. USING AS A WIRED HEADPHONE The Matrix comes with a 3.5mm audio jack on the left ear cup and an audio cable for wired use.
www.meelec.
