Taking pictures
± ± ± ±
FCC This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Caution: The user is cautioned that changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
Harmonic emissions IEC 61000-3-2 Class A *1 Voltage fluctuations/ Flicker emissions IEC 61000-3-3 *2 The device is suitable for use in all establishments, including domestic establishments and those directly connected to the public low voltage power supply network that supplies buildings used for domestic purposes. *1 For the regions where the rated voltage is 220 V or greater, this device complies with class A. For the regions where the rated voltage is 127 V or less, this standard is not applicable.
Guidance and manufacturer's declaration - electromagnetic immunity The device is intended for use in the electromagnetic environment specified below. The customer or the user of the device should assure that it is used in such an environment. Immunity test IEC 60601 test level Compliance level Electromagnetic environment - guidance Electrostatic Discharge (ESD) IEC 61000-4-2 ±8 kV contact ±2, 4, 8, 15 kV air ±8 kV contact ±2, 4, 8, 15 kV air Floor should be wood, concrete or ceramic tile.
where P is the maximum output power rating of the transmitter in watts (W) according to the transmitter manufacturer and d is the recommended separation distance in meters (m). Radiated RF IEC 61000-4-3 3 V/m 80 MHz to 2.7 GHz 80% AM at 1kHz 3 V/m 80 MHz to 2.7 GHz 80% AM at 1kHz Field strengths from fixed RF transmitters, as a determined by an electromagnetic site survey y, should be less than the compliance level in each b frequency range.