User Guide

ManualsBrandsMCHEETA ManualsAccessories & SuppliesCall Blocker for Landline Phones, Premium Phones with Call Blocking, One Touch Number Block Device, Block Unwanted Robocalls and Nuisance Calls

Table Of Contents

FAQ (Frequently Asked Question)

1. Q: how to unblock some accidentally blocked numbers?

A: Please hit "BLOCK" button first, then hit “left or right” arrow

to view the blacklist. Numbers are stored in numerical order. To

delete a displayed number, hit "DELETE" two times.

2. Q: how to use the handset to add an unwanted number

to blocker?

A: a: If answering an incoming call on a remote hand-set, press

“asterisk” (*) key once and hang up. “SAVE-SUCCEED” will

show on the display.

b: To add a telephone number to the blacklist manually, using

the hand-set, press asterisk key twice, enter number, press #

key to exit. (** + phone number + # ). “SAVE-SUCCEED” will

show in the display.

3. Q: Why does my blocker block cell phone calls without

my telling it to?

A: Please turn off BLOCK NO CID on call blocker. First press

the BACK/NO CID button, then press the DOWN button to

toggle the NO CID on to off. Press BACK when done.

B: Please delete any area codes from blacklist. Press BLOCK

button first, then use left or right arrow to review blocked

numbers. Area codes display with area codes plus two minus,

Summary of content (3 pages)

PAGE 1
FAQ (Frequently Asked Question) 1. Q: how to unblock some accidentally blocked numbers? A: Please hit "BLOCK" button first, then hit “left or right” arrow to view the blacklist. Numbers are stored in numerical order. To delete a displayed number, hit "DELETE" two times. 2. Q: how to use the handset to add an unwanted number to blocker? A: a: If answering an incoming call on a remote hand-set, press “asterisk” (*) key once and hang up. “SAVE-SUCCEED” will show on the display.
PAGE 2
such as " 524- -". Press DELETE twice to delete it. 4. Q. We got a busy signal when calling the a number, no ringing tone? (Putting numbers to blacklist by themselves who had not been blocked. ) A: Firstly, turn off BLOCK NO CID function. Secondly, switch to “1 ring” status as follows: Press BACK/NO CID for 3 seconds until “0 RING” shows on the screen. Then press up or down arrow to choose “1 RING”, and press BACK/NO CID to save. After that, the phone should have a dial tone.
PAGE 3
9: Q: Can not receive voice message since I installed blocker. A: If your landline is bundled with your TV/Internet service provider, please call your landline company to set up a voicemail box via your internet service account. 10：Q: Try to add a number to blacklist manually, double press star key but got busy signal, any suggestions? A: Please ignore the busy signal, just follow the instructions. Double click on the star button, enter the phone number, followed by the pound button to save.