Installation Instructions

FCC Statement
Changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment. This equipment has been tested and found
to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help This device
complies with part 15 of the FCC rules. Operation is subject to the following
two conditions (1) this device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that may
cause undesired operation.
The EUT was tested and rated under the American National Standard Institute (ANSI) C63.
19-2011 hearing aid compatibility standards. The ANSI standard for hearing aid compatibility
contains two types of ratings:
• M-Ratings: Rating for less radio frequency interference to enable acoustic coupling
with hearing aids.
• T-Ratings: Rating for inductive coupling with hearing aids in telecoil mode.
This device complies with the FCC HAC requirements has also been tested E-Field,
H-Field and T-Coil.
M-Ratings: Phones rated M3 or M4 meet FCC requirements and are likely to generate less
interference to hearing devices than phones that are not rated. M4 is the better/higher of
the two ratings. Your device is rated M4.
T-Ratings: Phones rated T3 or T4 meet FCC requirements and are likely to be more usable with
a hearing aid’s telecoil than phones that are not rated. T4 is the better/higher of the two ratings.
Your device is rated T3.
Model:LM5314G
2.0MPx
5.0MPx