User guide

Kwik-File, LLC
PEDESTAL TABLE
TP48, TP60, TP72
ASSEMBLY INSTRUCTIONS
1.With table upside down install table legs as per table
installation instructions.
Note: Pedestal may be installed on either left or right
side.
2. Remove drawers from pedestal. Extend drawers
and release the catch on each side of the drawers.
Pull drawers off the slides and push slides back into
the pedestal.
3. Mount rear Z-shaped bracket to top and align
mounting holes with 2 pre-drilled holes under table
top. Secure using two 3/4" long screws provided; use
a 3/8" socket. Install two 1/2" long screws as shown
into the 1/4-20 inserts in rear Z-bracket. DO NOT
TIGHTEN. Leave about a 1/4" gap between bracket
and screw head.
4. Attach front mounting bracket using four 3/4" long
screws and align mounting holes with the four
pre-drilled holes in the table top. Leave these screws
loose for now.
5. To mount pedestal, lift it so lip (in front of hole in top
of pedestal) rests inside the groove in the front
mounting bracket. Align rear keyholes in the top of the
pedestal with the 1/2" long screws (partially secured to
the rear Z-bracket). Pull pedestal forward so the
keyholes engage with the screw heads. Position the
pedestal flush with front of the table frame. Tighten
screws in front and rear brackets.
6. Flip table up on its legs.
7. Replace drawers in pedestal by extending slides
and reversing step #2. Be sure drawers slide in
completely, then lock in catches.
1/2" Screw
3/4" Screw
3/4" Screw