maycom MP-50 User's Guide
Information to user : PART 15, PARAGRAPH 15.21 AND 15.105(b) Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment FCC Notice NOTE : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
Contents About your maycom MP-50 Player .............................................................4 Unpacking your maycom MP-50 Player .....................................................5 At a glance...................................................................................................6 Specifications ..............................................................................................7 Installing Batteries............................................................................
About your maycom MP-50 Player The maycom MP-50 Player is the most convenient and easy-to-use way to enjoy music whereever you are. In order to make the most of your M P-50 Player read this user´s guide thoroughly.
Unpacking your MP-50 Player The following components are in the M P-50 Player box: MP-50 MP3 Player Additional Cover Stereo Headphones ‚ Owner´s Manual CD-Rom Carrying case(Optional) Clip (Optional) Note: All pictures are symbol pictures only. The actual look of items may vary.
At a glance Front view No Back view Description Key pressed for approx.
Specifications MP-50 Player • Maximum audio output power: 2x15mW • Signal to noise ratio: >90dB • Frequency response: 20 Hz – 20 KHz • Maximum total harmonic distortion: 0.3% • Headphone impedance: 16 ohm • Power consumption at 128 kbps MP3 decoding at volume level 15, no EQ: approx. 90mA • Playing time with new set of batteries: approx. 8-10 hours • Dimensions (mm): W86 x D55 x H32 • Weight without batteries: 52g • Power Supply: min. 2.
Installing Batteries Install 2 AAA batteries* into your M P-50. You may use alkaline batteries or NiMh rechargable batteries (NOT NiCd). 1) To release battery cover press down where in dicated. 2) Open the cover. 3) Insert batteries according to polarity diagram. 4) Replace cover. the battery A new set of alkaline batteries provides an MP3 play time of approximately 8-10 hours.
Exchanging Covers 1) Open the MMC door. At the marking indicated in the above picture, gently lift the cover towards you until you hear a click. 2) Loosen the cover below the menu key and below the headphone jack. 3) The cover can now be removed. 4) To replace the cover simply snap it into place over the front of the M P-50 Player. Never use force to remove the cover. Damaged covers are not covered by the warranty.
Installing the USB driver in Windows 1) Turn on your PC and the M P-50 Player. 2) Insert the M P-50 CD-Rom into your CD -Rom drive. 3) Connect the USB cable to your M P-50 Player where indicated: Carefully open the USB door. P lug in the smaller end of the USB cable. 4) Connect the larger end of the USB cable to your PC USB port. 5) Your PC will automatically detect M P-50. Depending on your version of Windows please turn to the appropriate page: Windows 98 ...............................................
Windows 98 1) Click "Next" to start the installation. 2) Select "Search for the best driver" and click "Next". 3) Select "Specify a location" and browse the CD to locate the correct path of the driver (e.g. D:\USB_Driver). Click "Next".
4) After locating the driver the system asks for confirmation. Click "Next". 5) Click "Finish" to complete the installation. Turn to page 17.
Windows 2000 1) Click "Next" to start the installation. 2) Select "Search for a suitable driver" and click "Next". 3) Select "CD-ROM drives" and click "Next".
4) After locating the driver the system asks for confirmation. Click "Next". 5) Click "Finish" to complete the installation. Turn to page 17.
Windows ME 1) Select "Automatic search" and click "Next". Windows ME will search the CD-ROM drive for the appropriate driver. 2) Click "Finish" to complete the installation. Turn to page 17. Windows XP 1) Select "Install the software automatically" and click "Next".
2) Should the following message appear ignore it and click "Continue Anyway". Visit the support section of www.emaycom .com for further information on this message. 3) Click "Finish" to exit the Wizard. After successful installation: The driver installation has been completed. For information how to copy files continue on this page. To install MusicMatch Jukebox see page 29.
Copying files to the MP-50 Player in Windows 1) Decide whether you want to access the internal memory or an M MC. To access an MMC, insert it into the M P-50 Player (see page 26) and switch to it (see page 27). 2) Connect the M P-50 16 Player to your PC. 3) In Windows Explorer find the drive letter representing the removable disk (Drive E: in our example below). If there is an MMC installed, the icon represents the MMC. If there is no MMC installed, it represents the internal memory.
The M P-50 Player can also be used like a floppy disk. You may copy all types of files to the internal memory for portability. However, only MP3 files can be played by the M P-50 Player. If you are using a MultiMediaCard, the M P-50 Player has the function of an MMC Reader (similar to a floppy disk drive). You may use it to read and write any data to or from the MMC. However, only MP3 files can be played by the M P-50 Player.
Macintosh Operation Since the M P-50 Player is a USB mass storage class device, no driver needs to be installed. 1) Decide, whether you want to access the internal memory or an MMC. To access an MMC, insert it into the M P-50 Player (see page 26) and switch to it (see page 27). 2) Connect the USB cable to your M P-50 Player: Carefully open the USB door. Plug in the s maller end of the USB cable. 3) Connect the larger end of the USB cable to your Macintosh. 4) A removable disk icon appears on the desktop.
Beware: Never insert or remove an MMC before having ejected and disconnected the M P-50 Player from the Macintosh. If the internal memory is used, the volume´s name is " maycom". If the M P-50 Player was connected to your Macintosh with an MMC installed, the name of the volume is the name of the MMC ("Untitled" in the example below). Internal Memory Mac OS Classic MMC installed maycom Mac OS X maycom The M P-50 Player can also be used like a floppy disk.
Operating the MP-50 Player Connect your earphone set to the earphone jack. Use the 6 major keys for basic operation: Key Short Press Stop Play / Pause Skip to previous song Skip to next song Display artist/title** A-B Repeat*** Long Press Power On/Off Internal memory/MMC* Rewind Fast Forward Keylock On/Off Format (erase) internal memory * see page 27 for details. ** if the file does not contain a supported ID3 tag the filename will be displayed. *** see Play Modes on page 25.
Keylock Push and hold to lock all keys and to protect current settings. To unlock, push and hold once again until the indication on the LCD disappears. The Menu Key Your M P-50 Player is equipped with a menu key. This key is used for the following functions: Move the key to adjust the volume. Push the key to enter the menu of the M P-50 Player. Within the menu use this same key to browse through the menu. Within the menu push this same key to select the function displayed.
The Menu / Menu Tree / Equalizer The following functions are controlled through the menu: • Equalizer • Play Mode The menu tree below shows where you can find specific set tings: Use the Equalizer to adjust the sound to suit your personal preferences. If a setting other than "NORMAL" is active is displayed on the LCD.
Play Modes • Repeat one (RPT) Select this function to repeat the current track. The LCD displays . • Repeat all (RPT ALL) Select this function to repeat all the tracks. The LCD displays . • Random (RND) Select this function to switch playback to random mode. The LCD displays . • Intro (INTRO) Select this function to play the first 10 seconds of each track. The LCD displays . • Normal Select "Normal" to reset to normal mode. • A-B Repeat This function is controlled by the key.
Using the MMC Expansion Slot The M P-50 Player is equipped with an expansion slot for additional memory. You may use a MultiMediaCard (MMC) of any size. If an MMC is installed you can use the M P-50 Player as an MMC Reader. This means you can read and write files (not only MP3 files) to and from the MMC while the M P-50 Player is connected to your computer. Inserting a MultiMediaCard 1) Open the MMC door. 2) Insert shown. 3) Close the MMC door.
Selecting the source for playback If you have a MultiMediaCard installed press for 2 seconds to switch from the internal memory to the MMC and vice versa.
Removing a MultiMediaCard 1) Open the MMC door and gently press the MMC in the direction shown. 2) The MMC will be released and should pop out. You may now remove the MMC. 3) Close the MMC door.
Installing Music Match Jukebox Minimum system requirements Operating system: Windows98 or later CPU: Pentium 166MHz or better RAM : 32MB or more 256 colours or better 4x speed CD-ROM drive USB interface Sound system: 16 bit or better 1) 2) Turn on your PC. Insert the M P-50 CD-Rom into your CD-Rom drive. Access the CD by double-clicking the icon representing the CD-Rom drive. maycom(D:) 3) Double-click the "MusicMatch Jukebox" folder.
4) Within the "MusicMatch Jukebox" folder, highlight the file "Setup" and double-click to begin the installation. 5) Click "Next". 6) Choose "YES" to accept the license agreement.
7) Complete the f orm and click "Next". 8) Choose whether you would like your listening preferences to be transferred to MusicMatch. Select "Yes" or "No". Then click "Next" to continue.
9) Choose "Express" installation, then click "Next". 10) Click "Finish" to complete the installation.
Encoding MP3 files from Audio CDs 1) 2) 3) 4) 5) 6) Start Music Match Jukebox. Insert an Audio CD into your CD-Rom drive. Music Match Jukebox should automatically detect the CD. (If not, please ensure that MusicMatch Jukebox is selected as you default CD Player.) Select the tracks in the recording dialog box which you would like to encode into MP3 files and edit the track information for identification. Click "REC" to start encoding.
Static discharge Your M P-50 Player consists of sophisticated and sensitive circuitry. There may be occasions when the player is affected by static discharge. When you move around, your body naturally builds up some electricity, which can cause what is known as static discharge. Should your M P-50 Player at any time appear to freeze operation, and you have already verified that the batteries are properly installed it is possible the player has been affected by static discharge.
Storing & Handling • Keep the MP-50 Player at room temperature . Direct sunlight or extreme temperatures can damage electronic products. • Keep the MP-50 Player away from moisture. Moisture or humidity may cause the M P-50 Player to short circuit. If exposed to moisture, immediately dry the player with a soft cloth. • Do not use the MP-50 Player outdoors in poor weather conditions, such as rain or lightning. • Protect the MP-50 Player from shock.
Maycom B/D, 280-5, Seoksu 2- Dong, Manan-Gu, Anyang- City, Kyongki- Do, Korea Tel : +82 (0)31-470-7700 Fax : +82 (0)31-472- 3700 http://www.emaycom.com e- mail : maycom@emaycom.
