User's Manual
WIRELESS CONTROLLER
INSTRUCTION MANUAL(ENGLISH)
Safety Information:
1. The protective silicon skin and wrist-strap
must be used at all times to avoid
accidental damage or injury.
2. Always make sure there is sufficient room
in which to play.
Installing Batteries:
1. Wireless Controller requires 2 x AA
batteries (not included).
2. Remove battery cover and insert batteries
– please note correct polarities.
3. Then replace battery cover.
4. Please note safety information on the
packaging of the batteries used.
Controller Set-Up:
1. Turn on your Wii™ console.
2. Remove the battery cover from Wireless
Controller and press the “SYNC” button.
The player LEDs will flash.
3. Open SD card slot cover on the front of
your Wii™ console, then press and release
the “SYNC” button on inside of
compartment. When the player LEDs stop
flashing set-up is complete.
4. The LED that is illuminated donates your
player number.
Caution: The user is cautioned that changes or
modifications not expressly approved by the
party responsible for compliance could void
the user's authority to operate the equipment.
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following
two conditions: (1) this device may not cause
harmful interference, and (2) this device must
accept any interference received, including
interference that may cause undesired
operation.
Note: This equipment has been tested and
found to comply with the limits for a Class
B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to
provide reasonable protection against
harmful interference in a residential
installation. This equipment generates,
uses and can radiate radio frequency
energy and, if not installed and used in
accordance with the instructions, may
cause harmful interference to radio
communications. However, there is no
guarantee that interference will not occur
in a particular installation. If this
equipment does cause harmful
interference to radio or television
reception, which can be determined by
turning the equipment off and on, the user
is encouraged to try to correct the
interference by one or more of the
following measures:
—Reorient or relocate the receiving
antenna.
—Increase the separation between the
equipment and receiver.
—Connect the equipment into an outlet on
a circuit different from that to which the
receiver is connected.
—Consult the dealer or an experienced
radio/TV technician for help.
This equipment complies with FCC
radiation exposure limits set forth for an
uncontrolled environment. End user must
follow the specific operating instructions
for satisfying RF exposure compliance.
This transmitter must not be co-located or
operating in conjunction with any other
antenna or transmitter.