User's Manual

ManualsBrandsMaximum ManualsElectronicsWireless weather instrument

Maximum Wireless

Installation Instructions

Introduction

Thank you for purchasing A Maximum Wireless Weather instrument.

Maximum Wireless Instruments are designed with the customer in mind.

It’s ease of installation and operation enables the Do It Yourself consumer

to install the instrument. If you need assistance, consult a contractor,

electrician, or television antenna installer.

Components

Receiver Wind Transmitter Temperature Transmitter Rain Transmitter

Wiring

Pre-Wiring and Test Locations

It is important to pre-wire and test operation before final installation

can begin.

Receiver/Instrument

Connect the AC power wires from the Receiver (Blue and Green

wires) to the AC Power terminals of the Brass Instrument (DO NOT

APPLY POWER).

Connect the White wire from the Receiver to terminal #1 (Rx) of

the Brass Instrument.

Connect the Black wire from the Receiver to terminal #2 (GND) of

the Brass Instrument.

• If an additional instrument (except Rainwatch, or Cronus) is also being

installed use the enclosed jumper wire for connection between

instruments.

• Connect one end of the WHITE wire to terminal #3 of the 1

instrument

(Tx), and BLACK wire to terminal #2 of the 1

instrument (GND).

• Connect other end of the WHITE wire to terminal #1 of the 2

Instrument (Rx), and BLACK wire to terminal #2 of the 2

instrument

(GND).

Receiver/Rainwatch

Connect the Yellow wire from the receiver to terminal #4 of the

Rainwatch.

Connect the Brown wire from the receiver to terminal #5 of the

Rainwatch.

Summary of content (5 pages)

PAGE 1
Maximum Wireless Installation Instructions Introduction Thank you for purchasing A Maximum Wireless Weather instrument. Maximum Wireless Instruments are designed with the customer in mind. It’s ease of installation and operation enables the Do It Yourself consumer to install the instrument. If you need assistance, consult a contractor, electrician, or television antenna installer.
PAGE 2
Maximum Wireless Installation Instructions Cont. Wind Transmitter Insert the two enclosed AA Ni-Cad batteries into the enclosed battery charger (be sure to observe Polarity) and charge batteries for 12 hours. (Do not attempt to charge any batteries other than NI-Cad batteries. This could cause the batteries to explode, possibly causing physical damage or fire). Connect the sensors to the Wind Transmitter wire.
PAGE 3
Remove the top of the Rain Collector by loosening the four Phillips head screws and rotating the top off. Remove the blue cover to access the circuit board. Place the jumper on the Test position. TESTING/SENSOR INSTALLATION Please follow directions in this order Instrument Display Move the Instrument Display near the location where they will be installed. (They may lie on a table or floor for testing). Connect the AC Power adaptor enclosed with the instrument to each specific instrument.
PAGE 4
If you loose the signal (Light does not blink), try alternate mounting locations for the temperature sensor. Once location is established remove the battery, and the test jumper. (Leave Battery disconnected). Wind Transmitter Remove the Ni-Cad Batteries from the charger once they are fully charged. Install the Batteries inside the Wind Transmitter Case. The Red Light on the Receiver box should light every 2 seconds. Remove the jumper from the test position.
PAGE 5
Information for the Wireless Instrument user Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.