User Manual Product name :RC01 1、 ID
、 Electric Capability N0 Item Test Requirements 2.0 IC IC Mcu RTL8752CJF 2.1 remote control model RC01 2.2 Carrier frequency 2402----2480MHZ 2.3 Working Voltage DC 3v 2.4 Static Current 6uA~500uA 2.5 Working Current <30mA 2.6 RF distance IR>8m IR 15°>6m RF>10m Working Voltage(3V) 2.7 Mouse operating distance 2.8 2.9 Supported Operating Systems Code Table >10m Android4.3 or above Refer to the Code Table 2.10 Schematic Diagram Refer to Schematic Diagram 2.
.3 Storage Temperature 3.4 Storage Humidity 3.5 Test temperature The RCU shall be capable of operating after being stored in an ambient temperature range of -40º to +70ºC. The RCU shall be capable of operating after being stored in a relative humidity range of 5% to 90%, non-condensing. -10 ºC ~ 50 ºC 4、Key introduction and code value 1) If Bluetooth is not connected or disconnected, infrared is emitted by default. 2) Infrared code format: NEC format.
16 17 Menu Preset bit 0x0C 0x40 KEY_MENU 0x46 0x07 0x99 KEY_CVTE_CAM_POS 0x51 0x07 0x9a KEY_CVTE_HANGUP 0x09 switching Turn off the camera 18 5) Function Description (1) The Bluetooth status of the remote control is not connected, and all the keys of the remote control send infrared code value.
the prompt screen. (5) If the coding is still unsuccessful within 2 minutes, the remote control will automatically return to the original state. (6) When the Bluetooth is paired, press and hold the Back button +Home button on the remote control for 3 seconds, the remote control will clear the pairing information first, then send an infrared code value 0x0A, close the Bluetooth (no longer initiate pairing broadcast), and the UC terminal will clear the Bluetooth connection record at the same time.
(10) To adjust the sensitivity, long press the confirm key for 2 seconds, and then press the volume +- to adjust the sensitivity. 8) Others (1) Bluetooth is turned on by default after the first startup, and Bluetooth pairing is prompted.
7、Packing
FCC Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
two conditions: (1) This device may not cause interference. (2) This device must accept any interference, including interference that may cause undesired operation of the device. L'émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d'Innovation, Sciences et Développement économique Canada applicables aux appareils radio exempts de licence.