User's Manual

MAXELL CONFIDENTIAL

Cautions

・Since this module is not sold to general end users directly, there is no user manual

of module.

・

r the details about this module, please refer to this specification sheet of module.

・

This module should be installed in the host device according to the interface

specification (installation procedure).

・This module complies with below part 15 of the FCC Rules.

Part 15 Subpart C

・The modular transmitter is only FCC authorized for the specific rule parts (i.e., FCC

transmitter rules) listed on the grant, and the host product manufacturer is responsible

for compliance to any other FCC rules that apply to the host not covered by the

modular transmitter grant of certification.

The final host product still requires Part 15 Subpart B compliance testing with the

modular transmitter installed.

・

isplay the following on the final product.

①

Contains Transmitter Module FCC ID: UOEME-M23D

②

This device complies with part 15 of the FCC Rules. Operation is subject to the

following two conditions: (1) This device may not cause harmful interference, and (2)

this device must accept any interference received, including interference that may

cause undesired operation.

・

isplay the following on the User Manual of final product.

①

Properly shielded and grounded cables and connectors must be used for connection

to host computers and / or peripherals in order to meet FCC emission limits.

②

FCC CAUTION

：

Changes or modifications not expressly approved by the party

responsible for compliance could void the user’s authority to operate the equipment.

PAGE 1
C Cautions ・Since this module is not sold to general end users directly, there is no user manual of module. ・For the details about this module, please refer to this specification sheet of module. ・ This module should be installed in the host device according to the interface specification (installation procedure). ・This module complies with below part 15 of the FCC Rules. Part 15 Subpart C ・The modular transmitter is only FCC authorized for the specific rule parts (i.e.
PAGE 2
3.3 Appearance of Exclusive Antenna Cable Appearance of exclusive antenna cable is shown below. Cable length : 500 mm (standard value) Connector housing: For PH-2pin Ferrite core : TDK ZCAT1325-0530A 1 turn 100 mm Reader/Writer side 500±15mm Antenna side Fig. 3-3 Appearance of Exclusive Antenna Cable 3.6 Ferrite Core Recommended Position 50mm RS-232C(Host Side) Ferrite Core TDK ZCAT1518-0730 1 turn PH-5pin(Reader/Writer Side) Fig.