Installation Instructions

❶ Press and hold for 2 Seconds with Remote controller(push button) until it

show 1 LED lights (Low heat).

❷ Tap ( click once) click or push the push button to select your desired temperature

❸ Press and hold the push button on the remote controller for 2 seconds

the Indicator lights will turn off.

1. Check remote controller battery level:

❶ Click the push button on the remote controller.

❷ The indicator light will flash briefly to indicate remaining charge:

2. Charging your wristband remote controller

❶ Push wristband remote controller onto charging stand.

❷ Connect with USB charging cable.

❸ Connect USB charging cable to an adaptor, and plug into a power outlet.

PAGE 1
❶ Press and hold for 2 Seconds with Remote controller(push button) until it show 1 LED lights (Low heat). ❷ Tap ( click once) click or push the push button to select your desired temperature ❸ Press and hold the push button on the remote controller for 2 seconds the Indicator lights will turn off. 1. Check remote controller battery level: ❶ Click the push button on the remote controller. ❷ The indicator light will flash briefly to indicate remaining charge: 2.
PAGE 2
1. When the remote control charge reaches 30%, one of the LEDs will stop flashing (the other two LEDs flash alternately.) 2. When the remote control charge reaches 60%, the two LEDs stop flashing (one LED will remain flashing.) Caution: The user is cautioned that changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with Part 15 of the FCC Rules.