User's Manual

ManualsBrandsMatias ManualsComputers & AccessoriesMATIAS ONEKEYBOARD

Matias One Keyboard for iPhone & Mac

Setup Instructions

System Requirements

Mac with available USB port

iPhone 3GS or newer, iPod touch 3rd generation (2009) or newer

Plug the One Keyboard

into your Mac

Press the

iPhone button

It should start flashing

blue

If it's not flashing, then

hold it down for a few

seconds until it starts

flashing

Open the Settings app on

your iPhone or

iPod touch

Tap on General

Summary of content (6 pages)

PAGE 1
Matias One Keyboard for iPhone & Mac Setup Instructions System Requirements Mac with available USB port iPhone 3GS or newer, iPod touch 3rd generation (2009) or newer Tap on General Plug the One Keyboard into your Mac Press the iPhone button It should start flashing blue If it's not flashing, then hold it down for a few seconds until it starts flashing Open the Settings app on your iPhone or iPod touch
PAGE 2
Tap on Bluetooth When the keyboard appears, tap on Not Paired If Bluetooth is off, tap the OFF button to turn it ON Bluetooth will begin searching for devices
PAGE 3
A message telling you the passkey will appear The keyboard is now connected and ready to be used Type the passkey on the numberpad Then press the Enter key
PAGE 4
To switch between iPhone & Mac, press the iPhone button on the keyboard The button glows blue when connected to your iPhone The button is white when connected to your Mac REMEMBER... Bluetooth keyboards prevent the onscreen keyboard from appearing There two ways to make it reappear...
PAGE 5
APPENDIX FCC Warning Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to part 15 of the FCC Rules.
PAGE 6
APPENDIX Declaration of Conformity for R&TTE directive 1999/5/EC Essential requirements – Article 3 Protection requirements for health and safety – Article 3.1a Testing for electric safety according to , EN50392 and EN 60950-1 has been conducted. These are considered relevant and sufficient. Protection requirements for electromagnetic compatibility – Article 3.1b Testing for electromagnetic compatibility according to EN 301 489-1 and EN 301 489-17 has been conducted.