User Manual 1
Content Knowing Your Phone ............................................................. 3 Inserting the SIM Card and SD card ....................................... 3 Charging the battery ............................................................. 3 Battery Performance ............................................................. 4 Basic Operations ................................................................... 5 Making a call .........................................................................
Knowing Your Phone Inserting the SIM Card and SD card You must insert 4G LTE USIM card is on the phone to enjoy and enable all the features. Your card contains all your subscription information. Please insert the SIM card or SD card by following below instructions. Then press and hold the power button to turn your phone on or off. This phone supports external Micro-SD card. The memory card should be inserted into the card slot correctly to the position line. Please follow the picture shown above.
If 4G LTE USIM card is not installed, or there are errors in the insertion, or the card is damaged, “No service” notification will appear on the screen after your phone is powered on. If the PIN is enabled you need input the PIN number to unlock it before you contrast using the phone. Please power off the phone before you are ready to insert the SIM card and SD card. If not, the SIM card and SD card might become damaged. Charging the battery New batteries are shipped partially charged.
3. When your phone indicates that the battery is fully charged, remove the charger. Notes: ● ● ● ● ● ● ● ● The battery is not removable, please use the original battery and charge. Your phone is designed to be used only with original batteries and chargers The battery can discharge gradually even when your phone is powered off. If the battery is drained for a long time, the information stored in the phone could possibly be lost.
conditions, phone’s settings, frequent operations, using data services, etc. The battery performance is also affected by charge state and temperature. Basic Operations Turning on and off the phone To turn on the phone: Press and hold Power key for more than 3 seconds to turn on your phone. Turn off the phone: Press and hold Power key to pop up option menu, select “power off”. If it is powered off you cannot receive, make a call or do other operations.
5. Touch to add call 6. Touch to recording the call. 7. Touch to end the call. To see the setting of voice mail, you can do the following: Touch enter dialer Menu Settings Calling accounts Card1 or Card2 Voicemail. Inside the voice mail settings, you can see or edit the number. You can dial the voice mail number manually from the dial pad. To see the settings of call forwarding, you can do then following: enter dialer Menu Settings Calling accounts Touch Card1 or Card2 Call forwarding.
If you don't need it, turn off automatic syncing for all apps: Settings Accounts. Or you can touch “Auto-sync data” to enable/disable it from taskbar. Note that this means you need to sync manually to collect messages, email, and other recent information, and won't receive notifications when updates occur. If you know you won't be near a mobile or WI-FI network for a while, switch to Airplane Mode. Check battery level and usage details Open SettingsDeviceBattery.
Bluetooth, or other menus displayed after pressing the menu key touch “ ”icon. To view this picture and others in the Gallery app, touch the picture. Install Micro-SD before taking any pictures or record videos or you may use the internal memory by turning the switching the storage location to phone. You might need to restart your phone after setting the storage to SD Card. Storing pictures and videos to your phone memory may consume the free space and when it gets low it will impact the phone performance.
You can activate the camera function when your phone screen is locked, by sliding the pad lock icon to the left toward the dialer icon, then the camera will open, as shown: Email You can configure Email for most accounts in just a few steps according the tip on the screen. The functions of the Email: 1. Receive email and view the text and attachments via your phone. 2. Reply and forward a received email. 3. And create a new Email. Apart from this, you also can set the inbox checking frequency .
For phone number: 1. You can click the keyboard to input number directly. 2. You can select number from messages, contacts or groups 3. You can select several numbers to send. 4. You can send multimedia message and attach the file by touching icon. Then you can send the pictures, video or audio as the you desired. to send the message, select by LTE/SIM1 network or 5. Touch SIM2 network.
interference. Mobile phones should be forbidden inside an operating theatre, Intensive Care Unit (ICU) or Cardiac Care Unit (CCU). Pay attention to the settings of the sound volume and the vibration to avoid disturbing the patients. Flammable or explosive areas Turn off your phone near flammable or explosive areas. Do not install/remove or charge the battery or use the phone in these areas to prevent any explosion or fire.
quickly contact the vendor. Do not store the phone, battery or charger in an environment with a strong magnetic field, such as an electromagnetic pot or a microwave oven, to avoid causing the phone to malfunction, catch fire or explode.
phone with a wet cloth to avoid short circuits, malfunction due to corrosion and electric shocks. Do not turn in or off the phone against your ear to avoid your ears and body from being impaired. To comply with regulations on radio frequency exposure, keep the antenna at least one inch (2.5 cm) away from your body when holding your phone or using its data functions.
Please observe the local regulations on phone packaging, battery and used phone disposal and bring them to the collection point for proper recycling. Do not dispose of used phones or batteries in a household rubbish bin. Please take your used, unwanted lithium batteries to a designated place. Do not dispose of them in a rubbish bin. Emergency call In an emergency situation, if the phone is on and you are within the network range, it can be used to make an emergency call.
Keep the charger away from any container of water or other liquids. Infiltration of liquid may cause electric leakage or other malfunction to the charger. If the battery leaks, emits smoke or a strange odour, cease use immediately and move it far away from naked flames or people to avoid a fire or injury from explosion. Do not charge the battery in a dusty or damp environment and keep the cable away from heated objects. The battery is not fully charged when leaving the factory.
Explanation: The instructions in this user manual apply to English mode. In other language operating modes, slight differences may appear. Warning: The manufacturer disclaims any liability for damage, which may result as a consequence of improper use of this mobile phone or use contrary to the instructions contained in this manual.
Warn Receivers associated with the operation of a licensed radio service: This device complies the FCC Rules. Operation is subject to the condition that this device does not cause harmful interference. All other devices operation is subject to the following two conditions: (1) This device may not cause harmful interference (2) this device must accept any interference received, including interference that may cause undesired operation.
D215 Pro STARTUP GUIDE GETTING STARTED Thank you for using Mason products. In this scope of this quick guide, we want to introduce to you some important basics and some precautions.
HOW TO INSERT THE SIM CARD AND MEMORY CARD 1. Setting up SIM and SD card 1) To remove the card tray, insert the SIM eject PIN included with your device into the small hole next to the card tray 2) The SIM card tray will pop-up. Withdraw the SIM tray 3) Insert a SIM card or micro SD into the card tray with the SIM’s chip surface facing downwards 4) Insert the card tray back into your device in the correct orientation 2. Press and hold the power button during 3~5 second to turn power on .
FCC Statement §15.19 Labeling requirements. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. §15.21 Information to user. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. §15.
Body-worn Operation This device was tested for typical body-worn operations. To comply with RF exposure requirements, a minimum separation distance of 1.0 cm must be maintained between the user’s body and the handset, including the antenna. Third-party belt-clips, holsters, and similar accessories used by this device should not contain any metallic components. Body-worn accessories that do not meet these requirements may not comply with RF exposure requirements and should be avoided.