USER’S MANUAL HIGH BAND WIRELESS MICROPHONE SYSTEM 440-1080-0
NOTE WIRELESS 12
WIRELESS NOTE WIRELESS MICROPHONE SYSTEM Table of Contents Page 1. Introduction …………………………………………………………….….….…….……….…… 1 2. Safety ………………………………………………………………………………….………….……… 1 3. Environment ………………………………………………………………………………………... 1 4. Wireless Note….………………………………………….………………………………..……... 1 5. Product Description …………….…………………..……………………..…….………..… 2 5.1 Receivers 5.2 Handheld Transmitter Microphone 5.3 Bodypack Transmitter 6. Basic Connections……………….…………………..……….…..……………….………..… 7 7.
WIRELESS WIRELESS NOTE FCC Statement This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1)This device may not cause harmful interference and (2) This device must accept any interference received, including interference that may cause undesired operation Notice: The changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
WIRELESS TROUBLESHOOTING 7.5 Setting up the bodypack transmitter 7.5.1 Connecting a microphone Use the supplied screwdriver to adjust the GAIN at appropriate position. Plug the 3.5 Ø plug of the microphone cable into the audio input jack on the bodypack transmitter. WIRELESS NOTE WIRELESS 5. Product Description 5.1 Receiver These are the stationary receivers for use with our VHF transmitters (DC3V operating voltage). The receiver operates in VHF band frequency with quartz locked controlled.
WIRELESS PRODUCT DESCRIPTION SETTING UP 5.1.3 Dual Channel, Non-diversity 7. Setting Up NOTICE: 1 WIRELESS 1 Prior to setting up, check that the transmitter and receiver are using the same frequency. Two or above transmitters operating in the same frequency can not be used at the same time and area, so please select the different frequencies which can be used simultaneously at local area. 7.1 Connecting the receiver to power Point the antennas upward.
WIRELESS PRODUCT DESCRIPTION PRODUCT DESCRIPTION 6. Basic Connections WIRELESS Rack Mounting Connect the receiver output to the mixer or amplifier input, using a standard audio cable with a 6.3ϕ phone plug. To combine two receivers in a 19” standard rack by using metal racks DC INPUT 12V 500mA AF OUT LINE MIC SQ 1 2 AUDIO MIXER LOUDSPEAKER 7 AMPLIFIER 1. Install 2 pieces ear short racks on both side sides of receiver. 2.
WIRELESS PRODUCT DESCRIPTION PRODUCT DESCRIPTION 5.2 Handheld Microphone WIRELESS 5.3 Bodypack Transmitter The handheld microphone operates in VHF high band frequency range 150~260MHz with quartz-locked control and integrated antenna design. Uni-directional dynamic or uni-directional electret condenser cartridge differ various characters for choices. Use 2 x 1.5V AA size batteries for low operating cost.