user’s manual The Great American Speaker Company
WARNING! • Refer servicing to a qualified technician. • To prevent fire or shock hazard, do not expose this module to moisture. • Turn amplifier off should any abnormal conditions occur. • Do not drive speaker beyond its rated power. The lightning bolt flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of potentially “dangerous voltage” within the Connection . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
x2 x1 3
Connection WARNING! Turn your amplifier off before making or breaking any signal connections! These speakers are designed with easy-to-use push-style binding posts that accept bare wire or pins (fig. 2). Additionally, by removing the rubber inserts, they will accept banana plugs (fig. 3) Assign the same color to the (+) and (–) terminals on both the speaker and the amplifier. Make certain that all connections are tight. Fig. 2 Fig. 3 4 Fig.
Fig. 4 Installation WARNING! Installation other than that described in the body of this document requires specifdocumentation from MartinLogan. ic BREAK IN Allow approximately 72 hours of break-in at 90 dB (moderate levels) before any critical listening. Note: This speaker is not magnetically shielded and therefore should not be placed directly beside or atop a CRT television. INSTALLING ON A WALL Note: These instructions assume the mounting surface is standard wood frame and sheet rock construction.
Fig. 6A Required hardware (not supplied): • (2) 1.5-inch Phillips sheet metal screws • (2) Sheet rock anchors Required tools (not supplied): • Ruler • Level • Electric drill and 1/4” and 1/8” drill bits • Phillips screwdriver 1 Screw the shoulder bolt into the back and install the rubber bumpers in the location shown (fig. 4). 2 Locate mounting location using a level and the installation template (fig. 5A–5B). Fig. 6B 3 Mark the pilot hole locations. 4 Drill the pilot holes using a 1/8-inch drill bit.
Frequently Asked Questions How do I clean my speakers? Use a dust free cloth (such as a micro fiber cloth) or a soft brush to remove dust from your speakers. Do not spray any kind of cleaning agent on or in close proximity to the drivers. Is there likely to be any interaction between my speakers and the television in my A/V system? Yes. These speakers are not shielded and should be kept at least 2 feet away from a CRT television.
General Information WARRANTY INFORMATION Your speakers are provided with an automatic Limited 90 Day Warranty coverage. You have the option, at no additional charge, to receive a Limited 5 Year Warranty coverage. To obtain the Limited 5 Year Warranty coverage you need to complete and return the Certificate of Registration to MartinLogan within 30 days of purchase. For your convenience MartinLogan also offers online warranty registration at www.martinlogan.com.
Specifications* MARTINLOGAN Electro Motion FX2 Frequency Response . . . . . . . . . . . . . . . . . . . . 55–25,000 Hz ± 3 dB Dispersion . . . . . . . . . . . . . . . . . . . . . . . . . . . . 160° (horizontal) x 30° (vertical) Sensitivity . . . . . . . . . . . . . . . . . . . . . . . . . . . . 93 dB @ 2.83 volts/ meter Impedance . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Ohms.
Dimensional Drawings 6.8” (17.2cm) 6,8 po (17,2cm) MARTINLOGAN ElectroMotion FX2 14.9” (37.9cm) 14,0 po (35,5cm) 14.0” (35.5cm) 14,9 po (37,9cm) ® The Great American Speaker Company Lawrence, Kansas, USA P/N: 9500067 rev. 2 10 tel 785.749.0133 fax 785.749.5320 ©2013 MartinLogan Ltd. All rights reserved. www.martinlogan.com Rev.
guide de l’utilisateur Le Grand Fabricant D’Enceintes Américain
AVERTISSEMENT! • Pour les réparations, faites appel à un technicien compétent. • Pour éviter les risques d’incendie ou de décharge électrique, n’exposez pas ce module aux vapeurs d’eau ni à l’humidité. • Veuillez éteindre l’amplificateur en cas de conditions anormales. • Ne poussez pas l’enceinte au-delà de sa puissance nominale. Le symbole de l’éclair avec une pointe en forme de flèche, dans un triangle équi- Raccordement. . . . . . . . . . . . . . . . . . . . . . . . . . .
x2 x1 13
Raccordement AVERTISSEMENT! Éteignez l’amplificateur avant de faire des raccordements ou d’interrompre tout raccordement de signal! Ces enceintes sont dotées de bornes de raccordement facile à utiliser de style bouton-poussoir qui acceptent les fils nus ou les broches (fig. 2). De plus, en enlevant les garnitures en caoutchouc, elles acceptent les fiches bananes (fig. 3) Attribuez la même couleur aux bornes (+) et (-) sur l’enceinte et l’amplificateur. Assurez-vous que tous les raccords sont bien faits.
Fig. 4 Installation AVERTISSEMENT! Une installation autre que celle décrite dans le présent document exige des documents particuliers de MartinLogan. RODAGE Un rodage d’environ 72 heures à 90 dB (niveaux d’écoute moyens) est nécessaire avant toute écoute critique. Remarque : cette enceinte n’est pas dotée d’une protection magnétique; par conséquent, vous ne devez pas la placer directement à côté ou audessus d’une télévision dotée d’un écran à tube cathodique (CRT).
Fig. 6A Matériel requis (compris) : • (1) Gabarit d’installation • (1) Support mural • (1) Boulon à épaulement • (2) Coussinets en caoutchouc Matériel requis (non compris) : • (2) Vis à tôle Phillips de 1,5 po • (2) Ancrages à Sheetrock (Gyproc) Outils requis (non compris) : • Règle • Niveau • Perceuse électrique et trépans de 1/4 po et 1/8 po • Tournevis Phillips Fig. 6B 1. Revissez le boulon d’épaulement et installez les coussinets en caoutchouc à l’endroit indiqué (fig. 4).
Foire Aux Questions Comment nettoyer les enceintes? Utilisez un linge exempt de poussière (comme un linge en microfibres) ou une brosse à poils doux pour enlever la poussière sur les enceintes. Ne vaporisez pas de produits nettoyants sur les haut-parleurs ou à proximité de ceux-ci. Peut-il y avoir une interaction entre mes enceintes et la télévision dans mon système A/V? Oui.
Renseignements Généraux RENSEIGNEMENTS SUR LA GARANTIE Vos enceintes sont vendues avec une garantie limitée automatique de 90 jours. Vous avez la possibilité d’obtenir, sans frais supplémentaires, une garantie limitée de cinq ans. Pour obtenir la garantie limitée de cinq ans, vous devez remplir et retourner le certificat d’enregistrement à MartinLogan dans les 30 jours qui suivent la date d’achat. Pour plus de commodité, MartinLogan permet également l’enregistrement en ligne à la garantie à l’adresse www.
Spécifications* MARTINLOGAN Electro Motion FX2 Réponse de Fréquence . . . . . . . . . . . . . . . . . . . 55–25 000 Hz ± 3 dB Dispersion . . . . . . . . . . . . . . . . . . . . . . . . . . . . 160° (horizontale) x 30° (vertical) Sensibilité . . . . . . . . . . . . . . . . . . . . . . . . . . . . 93 dB à 2,83 volts/mètre Impédance . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Ohms.
Plans Dimensionnels 6,8 po (17,2cm) 6.8” (17.2cm) MARTINLOGAN ElectroMotion FX2 14.9” (37.9cm) 14,0 po (35,5cm) 14.0” (35.5cm) 14,9 po (37,9cm) ® Le Grand Fabricant D’Enceintes Américain Lawrence, Kansas, USA P/N: 9500067 rev. 2 20 tél. 785.749.0133 téléc. 785.749.5320 ©2013 MartinLogan Ltd. Tous droits réservés. www.martinlogan.com Rev.