Instruction Manual

ManualsBrandsMartin Universal Design ManualsFurniture91-8009 VESUVIO CHAIR

IMPORTANT NOTICE

YOU WILL FEEL A SLIGHT

“BOUNCE-BACK” WHEN YOU SIT DOWN.

THIS IS NORMAL: NOT A DEFECT.

THE PNEUMATIC CYLINDER FOR THE

SEAT HEIGHT ADJUSTMENT REACTS TO

YOUR WEIGHT BY GIVING A LITTLE

VESUVIO Model’s

91-8006 & 91-8009

Assembled 91-8009

Parts

A. [1] Base Plate

Mechanism

B. [1] Cylinder

[a] 91-8006 model

[b] 91-8009 model

E. [1] 5-Star Base

G. [1] Backrest

H. [1] Seat

4444 Lawton Avenue, Detroit MI 48208 USA

Tel:(313)895-0700 • Fax:(313)895-0709

E-mail: Custservmud@aol.com

Visit us at: www.MartinUniversalDesign.com

Assembled 91-8006

F. [1] Foot Ring with Knob

Model 91-8006 only.

IMPORTANT

If you have difﬁculty assembling your chair or need customer service assis-

tance. Please call: Martin Universal Design, Inc. Customer Service Hot Line at

1-800-366-7337. If you need additional parts, it is not necessary to contact your

dealer, our Customer Service Rep. will forward them to you immediately.

K. [1] Black Cylinder

Bellows

Model 91-8009 only

Gray

Fabric

Black

Fabric

D. [1] Plastic Ring insert

Model 91-7706 only

(This part can be found in

the foot ring Part F)

C. [5] Castors

I. [10] M6x20 Hex Head Screws

[4] 3/4”

Plastic

Washers

for armrest

attachment

M. [2] Loop

Armrests

MUD 10/2009

Summary of content (2 pages)

PAGE 1
IMPORTANT NOTICE YOU WILL FEEL A SLIGHT “BOUNCE-BACK” WHEN YOU SIT DOWN. THIS IS NORMAL: NOT A DEFECT. THE PNEUMATIC CYLINDER FOR THE SEAT HEIGHT ADJUSTMENT REACTS TO YOUR WEIGHT BY GIVING A LITTLE VESUVIO Model’s 91-8006 & 91-8009 Black Fabric Gray Fabric Parts a. b. A. [1] Base Plate Mechanism Assembled 91-8006 Assembled 91-8009 B. [1] Cylinder [a] 91-8006 model [b] 91-8009 model C. [5] Castors D. [1] Plastic Ring insert Model 91-7706 only (This part can be found in the foot ring Part F) H.
PAGE 2
1. E 4. Model # 91-8006 7. M6x20 M6x20 C M6x20 M6x20 Model # 91-8009 Place 5-star base (E) face down and push [5] castors (C) into each position. 2. Attach armrests to bottom side of seat. Each Armrest (M) uses [3] M6x20 screws (I). Tighten with Hex-wrench. knob on foot ring weld Cut ends of plastic insert must run parallel with the weld. THIS STEP IS ONLY FOR MODEL 91-8006 ONLY. Before attaching foot ring (F) to cylinder (B).