User's Manual

60 K ingsb rid ge Road – P i s c at away, NJ 08854
Phone: [phone] f ax 908. 233.2227 o r 908. 233.4 1 11
www.mars int . c om
January 19, 2016
Re: FCC Submission – FCC Compliance paragraph from Manual
To Whom It May Concern:
The device under test is manufactured by the grantee (Martec Access Products) and sold as an
OEM product. Per 47 CFR 2.909, 2.927, 2.931, 2.1033, 15.15(b) etc…, the grantee must
ensure the end-user has all applicable / appropriate operating instructions. When end-user
instructions are required, as in the case of this product, the grantee must notify the OEM to
notify the end- user.
Martec Access Products will supply this document to the reseller/distributor dictating what
must be included in the end user’s manual for the commercial product.
INFORMATION TO BE INCLUDED IN THE END USER'S MANUAL
The following information (in blue) must be included in the end product user’s manual to
ensure continued FCC and Industry Canada regulatory compliance. The ID numbers
must be included in the manual if the device label is not readily accessible to the end
user. The compliance paragraphs below must be included in the user's manual.
*********************************************************************************
FCC ID: JCQTTI-TX
IC ID: 1907A-TTITX
This device complies with Part 15 of the FCC Rules and with Industry Canada license-exempt
RSS standard(s). Operation is subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) This device must accept any interference received,
including interference that may cause undesired operation.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes: (1) l'appareil ne
doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible d'en compromettre le
fonctionnement.
Note: Changes or modifications not expressively approved by the party responsible for
compliance could void the user's authority to operate the equipment. The term “IC:” before the
radio certification number only signifies that Industry Canada technical specifications were met.
*********************************************************************************
Best Regards,
Jason Manzi
Martec Access Products