User's Manual

Remote Control:Transmitter

The remote control transmitter has three buttons . Press and hold the

button to turn the swim current on. Press and hold the Up or

Down button to addjust the current to the desired speed . Press and

hold the button while the current is on to turn

This device complies with Part 15 of the FCC Rules. Operation is

subject to the following two conditions:

(1) This device may not cause harmful interference, and

(2) This device must accept any interference received, including

interference that may cause undesi red operation .

MODEL: EP-1g - 230 VAC, 24 AMPS, 60 Hz.

IP25 RATED RAINPROOF (TYPE 3R) ENCLOSURE SUITABLE FOR

INDOOR OR OUTDOOR USE

THIS UNIT REQUIRES 30 AMP 230 VOLT AC, SINGLE PHASE WITH

NEUTRAL, 60 Hz. (THREE COPPER WIRES PLUS GROUND)

Hydraulic Power Unit

5 HP 21 FLA Amps 230 VAC 60 Hz

6 HP 23 FLA Amps 230 VAC 60 Hz

HEATER CONTROLLER (optional)

24 Amps 230 VAC 60 Hz

Controller

IMPORTANT SAFETY INSTRUCTIONS: Read and follow all instruc-

tions. To reduce the risk of inju ry, do not permit child ren to use this

product unless supe rvised at all times. This control panel must be

installed according to local electric code requi rements . A GFCI

(Ground Fault Circuit Interrupter) or RCD (Residual Current Device)

circuit breaker must be used in the service panel and tested before

each use in accordance with the manufactu rer's instructions . The line-in

wire whip should be connected to a safety disconnect in sight of all

equipment , but at least 5 feet away from the pool. This controller must

be installed at least 5 feet away from the pool and all conductors must

not sha re boxes, conduits or enclosu res with non GFCI or RCD pro-

tected wiring . All wires must be coppe r. Box must be mounted with

conduit down.

WARNING: Changes or modifications not expressly approved by the

party responsible for compliance could void the user's authority to

operate the equipment.