Integration Manual

05
th
April 2006 Page 1 of 1
M1BT RF Interface – USER MANUAL
General Description
The “M1BT RF Interface” is a RF module, based on Murata LBMA49BAM2 Bluetooth pre-qualified module and
on pre-qualified CSR firmware RFCStack1.2.
The “M1BT RF Interface” module is not an end-product, it must be used in digital devices for RF communications.
The “M1BT RF Interface” module complies with Bluetooth specifications v.1.2 class 2.
Specifications
Name M1BT RF Interface
Manufacturer Marposs S.p.a.
via Saliceto 13 – 40010 Bentivoglio (Bologna) ITALY
www.marposs.com
Frequency range
2.400 ÷ 2.4835 Ghz
Max Transmit Power +4 dBm
Antenna max gain 0 dBi
Photo
USA – User information
This intends to inform how to specify the FCC ID of our module “ M1BT RF Interface ” on the product.
Based on the Public Notice from FCC, the host device should have a label which indicates that it contains our
module. The label should use wording such as:
“Contains FCC ID: NXIM1BT”
Any similar wording that expresses the same meaning may be used.
The label of the host device should also include the below FCC Statement. When it is not possible, this
information should be included in the User Manual of the host device.
“This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions. (1) This
device may not cause harmful interference (2) this device must accept any interference received, including
interference that may cause undesired operation.
Caution: Changes or modifications not expressly approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
Canada – User information
This intends to inform how to specify the IC ID of our module “ M1BT RF Interface ” on the product.
According to Canadian standards “RSS 210” and “RSS Gen” , the host device should have a label which
indicates that it contains our module. The label should use wording such as:
“Contains IC ID: 3066A-M1BT “
Any similar wording that expresses the same meaning may be used.
The label of the host device should also include the below IC Statement.
When it is not possible, this information should be included in the User Manual of the host device.
“Operation is subject to the following two conditions: (1) this device may not cause interference,and (2) this device
must accept any interference, including interference that may cause undesired operation of the device.”