Installation Instructions

REMOTE (WIRELESS) INSTALL KIT Manual
I. The working voltage is 12V-24V, and the maximum power is 160W.
II. Remote control button battery CR2032X1
III. Button function description
1. ON button - There are three modes to choose: Press the first time A
(position light) light on, press the second time B (main light) light on, press
the third time the A light and B light are on at the same time.
2. Button - Flashing mode, there are 6 flashing modes (click to switch one
mode), no matter which mode the ON button is in, you can press the button
to select the flashing mode. In any flashing mode, the A light and the B light
are always on once press the ON button.
3. OFF button - turn off the light
IV．Remote control and host code matching method
Press and hold the ON button of the remote control, power on the
controller, the light flashes four times and then stays on, indicating that
the code matching is successful.
When the light flashes four times and then stays on, press the ON button
of the second remote control and the light flashes four times to indicate
that the second remote control is successfully matched. By analogy, up to
10 remote controllers can be equipped, and 10 remote controllers can be
covered in a loop. After the code matching is successful, wait for 10
seconds to automatically end the code matching, or you can press other
buttons on the remote control to quickly end the code matching.
V．The remote control host has a mode memory function, no matter which
mode the ON key is and key is in, when the OFF key is pressed or the
mouse style switch is turned off and turn on again, it will automatically
enter the mode before it was turned off.
VI．When the mouse style switch is on and off (the indicator light is red), the
remote control cannot control the lights, and the remote control can only
control the lights when the mouse style switch is on.
VII．The battery should be replaced when the indicator light on the remote
control dims when pressing the remote control (or when the remote
control is too close).