v. 11.december.
1. IMPORTANT SAFETY INSTRUCTIONS 1) Read these instructions; 2) Keep these instructions; 3) Heed all warnings; 4) Follow all instructions; 5) Do not use this apparatus near water; 6) Clean only with dry cloth; 7) Do not block any ventilation openings.
2.CONTENTS AUX PHONES LEVEL Max Off VPF ON ON Max OFF AUX CLIP 0 LEVEL Max ON Off VLE Max Off VPF Max OFF INPUT ON MINIMARK 802 PRODUCT OVERVIEW 7 FUNCTIONS OVERVIEW (TOP PANEL) 7 FUNCTIONS OVERVIEW (REAR PANEL) 8 Technical specs 9 GRAPH 9 Block diagram 10 0 INPUT MICROMARK 801 Introduction 3 PRODUCT OVERVIEW 4 FUNCTIONS OVERVIEW (TOP PANEL) 4 FUNCTIONS OVERVIEW (REAR PANEL) 5 Technical specs 6 GRAPH 6 Block diagram 6 3.
. MICROMARK 801 PRODUCT OVERVIEW The Micromark 801 is a compact, high-quality bass combo amp with a solid-state preamp and an analog power amp, which delivers 45W of power into one yellow 8” Markbass neodymium woofer.
4.2 MICROMARK 801 FUNCTIONS OVERVIEW (REAR PANEL) SPEAKER ON/OFF (6) Use this switch to turn off the amp’s speaker when using headphones or using only the extension cabinet. LINE OUT (8) This balanced XLR output may be used for recording or live situations. Use an XLR cable to connect your amp to a soundboard, snake or soundcard. GROUND LIFT (7) When you detect a hum from your line out signal, switching the ground lift will more than likely eliminate it.
5. MICROMARK 801 TECHNICAL DETAILS INPUTS INPUT AUX INPUT Impedance: 500 Kohm, max. voltage: 8 Vpp Impedance: 33 Kohm, max. voltage: 20 Vpp CONTROLS VOLUME (Level) GROUND LIFT SPEAKER ON/OFF –60 dB to +25 dB range Switch on rear panel Switch on rear panel EQUALIZATION VPF (Variable Pre-shape Filter) Center frequency 380 Hz (cut) OUTPUTS LINE OUT HEADPHONE OUT Balanced XLR, max.
8. MINIMARK 802 PRODUCT OVERVIEW The Markbass Minimark 802 is a compact, high-quality bass combo amp with a solid-state preamp and an analog power amp, which delivers 150W of power into two yellow 8” Markbass neodymium woofers and a piezo tweeter. Connected to an 8 ohm extension cabinet, it delivers 250W of power. 8.1 MINIMARK 802 FUNCTIONS OVERVIEW (TOP PANEL) INPUT (2) The input jack accepts an unbalanced signal from your bass (active or passive) via a standard 1/4” instrument cable.
.2 MINIMARK 802 REAR PANEL SPEAKERS ON/OFF (11) Use this switch to turn off the amp’s speakers and extension cabinet (if applicable) when using headphones. LINE OUT (12) This balanced XLR output may be used for recording or live situations. Use an XLR cable to connect your amp to a soundboard, snake or soundcard. GROUND LIFT (13) When you detect a hum from your line out signal, switching the ground lift will more than likely eliminate it.
MINIMARK TECHNICAL DETAILS INPUTS INPUT impedance: 500 Kohm, max. voltage: 10 Vpp AUX INPUT impedance: 33 Kohm, max.
11. MINIMARK 802 GRAPHS VLE (min-max) 30 20 10 0 dB -10 -20 -30 -40 10 100 1000 Frequency - Hz 10000 100000 VPF (max) 15.00 dB 10.00 dB 5.00 dB 0.00 dB -5.000 dB -10.00 dB -15.00 dB -20.00 dB 10.00 Hz 10 100.00 Hz 1.000 kHz 10.00 kHz 100.
Product specifications are subject to change without notice Italy - 66020 San Giovanni Teatino (Ch) - Via Po, 52 - Tel. +39 085 446 3755 - Fax +39 085 440 7764 www.markbass.it - info@markbass.