User's Manual

Wireless Keyless Entry System
Instructions
FEATURES
Figure 1. Code Transferring
Figure 3. Batteries Replacing
The Wireless Keyless Entry System offers you the convenience
of opening and closing your garage door by entering your own
4-digit Personal Identification Number (PIN) via the keypad. It
can be programmed to control up to 3 garage door openers that
. It
Also an additional device (e.g. a yard light) can be controlled.
For that function (Light Function) an optional receiver is needed.
2
each work on a different code, or to control one garage door
opener with up to 3 different PINs can also be programmed to
allow a temporary PIN of your choice to be stored, to provide
temporary access to authorized visitors or service persons.
Check the package to familiarize yourself with the parts shown
in Figure .
Other Features Include:
Wireless Installation, Code Security, Anti-Tampering, and
Weather-Resistant Design
Step 1: Setting Up Your Personal Identification
Number (PIN) and Transferring the Code (fig. 1)
Your Keyless Entry System comes factory pre-programmed with
1 random code and 1 PIN. The factory pre-programmed PIN is
1-2-3-4. If you are using other remote control transmitters to
operate your garage door, the transmitter code must be
transferred to the Keyless Entry System from the active
transmitter you are already using.
Transferring the Code for Controlling your Garage
Door to the Keyless Entry System from a Transmitter:
Connect the Keyless Entry System to the active transmitter
using the programming connector.
Connect the Keyless Entry System to the active transmitter
using the programming connector.
Press and hold the transmitter button you use to open and
close your garage door. Keyless Entry System
.
On the , press
the ENTER button. The keypad illumination turns on
Press and hold the transmitter button you use to switch any
other device. Keyless Entry System
.
On the , press the ENTER
button. The keypad illumination turns on
The has now learned the code from the
transmitter, and stored it under the PIN that you entered.
.
Keyless Entry System
Programming connector can be removed
The has now learned the new code for
the light function from the transmitter.
.
Keyless Entry System
Programming connector
can be removed
Input any new 4-digit PIN of your choice. Press the ENTER
button again. Keep the transmitter button pressed until the
LED on the blinks rapidly.Keyless Entry System
Press the LIGHT button. Press the ENTER button again. Keep
the transmitter button pressed until the LED on the
blinks rapidly.
Keyless
Entry System
Backplate
2 Batteries 3V, CR 2032
Active Transmitter
Programming Connector
3-holed Terminal
Figure 2. Keyless Entry
System Mounting
Cover
Keypad Illumination
Mounting Screws
Anchors
Spacer
Key
LED
Mounting Hole
Transferring a new Code for the Light Function to the
Keyless Entry System from a Transmitter:
The Light Function is factory pre-programmed with its own code.
An existing transmitter code could be transferred to the Light
Function.