User Manual

ManualsBrandsMarantec America ManualsElectronicsDigital 384_ 4-channel and Digital 382_ 2-channel hand transmitter as accessory for garage door opener

TRANSMITTERS

Instruction for models

315 MHz: Digital 382, Digital 384

916 MHz: Digital 382, Digital 384

FEATURES

A family of state-of-the-art transmitters, each transmitter is custom

encoded and ergonomically designed to be an integral part of your

garage door opener system, with two styles to suit your personal

preference:

 Mini 2-channel: Digital 382,

 Mini 4-channel: Digital 384.

1. USING THE TRANSMITTER

All transmitters come with batteries already installed.

 To open or close garage door, press and hold the button. When

garage door begins to move release button.

 To stop the garage door during travel, press and hold button until

door stops, then release button.

 To continue the garage door travel after stopping it, press and

hold the button. Press button once, the door will travel in the

opposite direction.

2. TRANSMITTER MOUNTING (Figure 1)

The transmitters can be convenietly mounted on the wall (g. 1A)

using the mounting plate (optional) or inside your car using the visor

clip (g. 1B).

Mounting Plate (g. 1A)

The mounting plate enables you to mount the transmitter easily to

the wall or other area.

 Secure the mounting plate to area using screw and anchor.

 Slide the transmitter into the mounting plate, which will hold it

rmly in place.

Visor Clip (g. 1B)

The visor clip allows for easy mounting of the transmitter to a car

visor.

 Snap visor clip into transmitter.

Note: If you do not need the visor clip, install the visor

compartment cover.

3. BATTERY REPLACEMENT (Figure 2)

The transmitter has a battery check function, which checks the ca-

pacity of the battery during the transmission process. If the battery is

weak, the LED blinks during transmission.

When replacing batteries follow the steps below:

 Open the transmitter by using a narrow screwdriver.

 Insert a 3V battery (type CR2032) as shown.

 Close the transmitter.

Note: Replace batteries with same type only.

Figure 1: Mounting Plate & Visor Clip

Figure 2: Battery Compartment

g. 1A

g. 1B

Mounting Plate

(optional)

Visor Compartment

Cover

Battery

Visor Clip

Screwdriver

Summary of content (2 pages)

PAGE 1
TRANSMITTERS Instruction for models 315 MHz: 916 MHz: Digital 382, Digital 384 Digital 382, Digital 384 FEATURES A family of state-of-the-art transmitters, each transmitter is custom encoded and ergonomically designed to be an integral part of your garage door opener system, with two styles to suit your personal preference: Mini 2-channel: Digital 382, Mini 4-channel: Digital 384. Figure 1: Mounting Plate & Visor Clip fig. 1A 1.
PAGE 2
TRANSMITTERS Instruction (continued) 4. MULTIPLE TRANSMITTERS (Figure 3) Each transmitter comes factory programmed with random codes. 2-channel transmitters have 2 different random codes, one per button and 4-channel transmitters have 4 different random codes, one per button. Transmitters that are purchased separately as accessories have random codes that must be changed in order to match the code of the “active” transmitter, which you are already using.