User's Manual

ManualsBrandsMarantec America ManualsElectronicsRemote Control Transmitter

Table Of Contents

Transmitters

Instructions

for models: M3-2312, M3-2314, M3-3313

FEATURES

Mini (2- or 4-channel)

Micro (3-channel), the smallest transmitter of its kind.

3. Battery Replacement (fig. 2)

Open the transmitter by using small coin.

The installation of the battery for Mini and Micro is the same.

When replacing batteries follow the steps below:

Close the transmitter.

Note: Replace batteries with same type only.

Insert a 3V battery (type CR2032) as shown.

1. Using the Transmitter

2. Transmitter Mounting (fig. 1)

Mounting Plate (fig. 1A)

The mounting plate enables you to mount the transmitter easily

to the wall or other area.

Secure the mounting plate to area using screw and anchor

(not provided).

Visor Clip (fig. 1B)

Key Ring Attachment (fig. 1C)

The transmitters can be convenietly mounted on the wall (fig.

1A) using the mounting plate (optional) or inside your car using

the visor clip (fig. 1B). These two mounting alternatives (fig. 1a

and fig. 1B) are available with Mini models only. The Micro can

be used with the key ring attachment (fig. 1C).

Slide the transmitter into the mounting plate, which will hold

it firmly in place.

Open the Micro by using small coin.

Snap in the key ring attachment.

Close the transmitter.

To open or close garage door, press and hold the button (Mini

and Micro transmitters have indicator lights). When garage

door begins to move release button.

To stop the garage door during travel, press and hold button

until door stops, then release button.

To continue the garage door travel after stopping it, press and

hold the button. Press button once, the door will travel in the

opposite direction.

The visor clip allows for easy mounting of the transmitter to a

car visor.

The key ring attachment permits easy mounting of the Micro

to a key ring.

Snap visor clip into transmitter.

Note: If you do not need the visor clip, install the visor

compartment cover.

Figure 2. Battery Compartment

Coin

Battery

Figure 1. Mounting Plate & Visor Clip

fig. 1A

fig. 1B

fig. 1C Key Ring Attachment for Micro Transmitter

A family of state-of-the-art transmitters, each transmitter is

custom encoded and ergonomically designed to be an integral

part of your garage door opener system, with two styles to suit

your personal preference:

Visor Compartment

Cover

Visor Clip

Key Ring

Attachment

All transmitters come with batteries already installed.

Mounting Plate

(optinal)

Summary of content (2 pages)

PAGE 1
Transmitters Instructions for models: M3-2312, M3-2314, M3-3313 FEATURES A family of state-of-the-art transmitters, each transmitter is custom encoded and ergonomically designed to be an integral part of your garage door opener system, with two styles to suit your personal preference: Mini (2- or 4-channel) Micro (3-channel), the smallest transmitter of its kind. Figure 1. Mounting Plate & Visor Clip fig. 1A 1. Using the Transmitter All transmitters come with batteries already installed.
PAGE 2
Transmitters Instructions (continued) 4. Multiple Transmitters Each transmitter comes factory programmed with random codes. 2-channel transmitters have 2 different random codes, one per button, 3-channel transmitters have 3 different random codes and 4-channel transmitters have 4 different random codes, one per button. Transmitters that are purchased separately as accessories have random codes that must be changed in order to match the code of the "active" transmitter, which you are alredy using.