User's Manual

Instructions for Models: ML-143(1,2,4), ML-243(1,2,4), ML-343(1)
ML-140(1,2,4), ML-240(1,2,4), ML-139(1,2,4), ML-239(1,2,4)
Transmitters
FEATURES
A family of state-of-the-art transmitters is tailored for discerning
homeowner’s. Each transmitter is custom encoded and ergonomi-
cally designed to be an integral part of your garage door opener
system. Offering 3 styles to suit your personal preference: the
Midi (1-, 2- or 4-channel), the Mini (1-, 2- or 4-channel), and the
Micro (1-channel), the smallest transmitter of its kind.
1. Installing the Battery
Midi (Figure 1.A) and Mini (Figure 1.B)
■ Remove battery compartment cover (back of transmitter) by
using small screwdriver.
■ Insert the provided 12V battery (type 23A) as shown.
■ Replace battery compartment cover.
Micro (Figure 1.C)
Micro transmitters come with batteries already installed. When
replacing batteries follow the steps below:
■ Remove battery compartment cover (front of transmitter).
■ Insert two 3V batteries (type CR1025) as shown.
■ Replace battery compartment cover.
Note: Replace batteries with same type only.
2. Using the Transmitter
■ To open or close garage door, press and hold button (Midi and
Mini transmitters have indicator lights that will start blinking).
When garage door begins to move, release button.
■ To stop garage door during travel, press and hold button until
door stops, then release button.
■ To continue garage door travel after stopping it, press and hold
button. Once pressed, the door will travel in the opposite
direction.
3. Transmitter Mounting
The transmitters can be conveniently mounted inside your car
using the mounting plate, or the mounting plate and visor clip
(Midi and Mini Transmitters only).
Mounting Plate (Figure 2.)
The mounting plate enables you to mount the transmitter easily
to the dashboard or other convenient area.
■ Secure the mounting plate to area of preference using velcro
(not provided) or other means.
■ Snap the transmitter into the mounting plate, which will hold it
firmly in place.
Visor Clip (Midi and Mini Transmitters: Figure 2.)
The visor clip permits easy mounting of the transmitter to a visor.
■ Attach visor clip to mounting plate.
■ Snap transmitter into mounting plate.
■ Affix complete assembly to visor.
Programming
Cable
3-hole Terminal
Programming
Cable
3-hole Terminal
B. Micro Transmitter
A. Midi or Mini Transmitter
Figure 2. Mounting Plates & Visor Clips
C. Micro
Transmitter
B. Mini
Transmitter
A. Midi
Transmitter
Figure 1. Battery Compartment
Battery
Compartment
Cover
3V (type CR1025)
Battery
Programming
Cable
3-hole
Terminal
Micro Transmitter
Micro Mounting Plate
Transmitter—Midi
Mounting Plate
Visor Clip
Mini
Transmitter
Battery
Compartment
Cover
12V (type 23A)
Battery
Battery
Compartment
Cover
12V (type 23A)
Battery