User's Manual

McLelland MAP-KBT1 In-Wall Bluetooth Music Receiver

Instruction Manual

This MAP-KBT1 In-Wall Bluetooth Music Receiver keypad must be connected/powered by RJR-2 Convertor

thru RJ45/CAT5 cable from the rear panel of MAP-KBT1 to the RCA input from the amplifier system.

Bluetooth pairing:

§ The first pairing, press and hold down the Bluetooth Pairing button 5 seconds until the Blue and Red

LED begins to blink quickly, and look for the device ID “MAP-KBT1”, the LED will be shown as solid Blue

when the pairing success.

§ The pairing mode timeout limit is 180 seconds, the MAP-KBT1 will be power off if there is no device

connected.

§ To disconnect, press and hold the Bluetooth Pairing button for 5 seconds until the LED turns off.

Specifications & Feature:

* Signal and Power Pair Pass-Through on RJ45 Jack.

* Local Power input on RJ45 Jack.

* Bluetooth indicates Module is Powered.

PAGE 1
McLelland MAP-KBT1 In-Wall Bluetooth Music Receiver Instruction Manual This MAP-KBT1 In-Wall Bluetooth Music Receiver keypad must be connected/powered by RJR-2 Convertor thru RJ45/CAT5 cable from the rear panel of MAP-KBT1 to the RCA input from the amplifier system.
PAGE 2
FCC Certification Requirements Caution: Any changes or modifications in construction of this device which are not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.