5100 series 5.
INTRODUCTION Thank you for purchasing the MANHATTAN ® 5100 Series 5.1 Multimedia Speaker System, Model 160858. These speakers feature internally powered amplifiers, making them compatible with computers and CD and DVD players, including portable versions of such devices. They are also completely shielded in terms of magnetization, and so will not interfere with the performance or operation of your computer or TV monitor.
safety precautions Prior to the installation of your speakers, read the following safety guidelines to help prevent damage to any electrical components or harm to users. • Do not place this product or any of its parts near heat or potential heat sources, nor in any moist or damp environment. • Do not hit, drop or mishandle electrical components in such a way as to loosen, break or otherwise render inoperative any interior or exterior parts.
SETUP Subwoofer 1. Carefully unpack the speakers and accessories. Do not lift or remove the speakers from the box by the function knobs or other attachments as this may damage the speaker unit. 2. Place the satellite speakers and subwoofer in the desired listening location. (See the configuration example in Suggestions for Setup & Operation.) Right/left, front/rear satellite speaker Center speaker 3.
main power button (also on the rear panel of the subwoofer) to the on position. This allows you to then use the more convenient power buttons on the front of the subwoofer and on the remote control to turn the speaker system on and off. 6. With the audio source turned on and generating an audio signal, adjust the volume and bass level of the speaker system to desired levels (adjusting the volume/audio output level on the audio source as necessary).
• UP/DOWN — Volume is controlled with the UP and DOWN buttons, with the corresponding LEDs flashing during volume adjustment. If the UP or DOWN LED doesn’t flash while its volume button is pressed, the level is at maximum. NOTE: To adjust the volume of individual and pairs of speakers, use the UP and DOWN buttons in conjunction with the MODE button (see below). • STEREO/5.1 CH — Based on the current audio source, press the Stereo button (CD mode) or the 5.
• IR — The infrared receiver (IR) accepts the signal from the remote control. Make sure nothing is placed in front of the receiver (or between the receiver and the remote control) that could interfere with the signal. Remote control The buttons on the remote control unit work in a similar fashion to those on the front panel of the subwoofer (POWER, MUTE, 5.
Suggestions for Setup & Operation • Though featuring a magnetically shielded design so the speaker system is free from interference when placed near a monitor or TV, the subwoofer can cause interference in other components. Position the subwoofer at least 30 cm (1 ft.) away from monitors and TVs. • If only one speaker emits CD audio when the system is plugged into a headphone jack, it’s because WAV files and games normally transmit only one track of audio.
SPECIFICATIONS • RMS output power: 10 W + 5 W x 5 • Frequency response: Satellites: 200 Hz – 18 kHz Subwoofer: 40 Hz – 300 Hz • Signal to noise ratio (S/N): ≥ 70 dB • Total harmonic dstortion (THD): ≤ 0.3% • Impedance: Satellites (front, center, rear): 4 Ohms Subwoofer: 4 Ohms • Dimensions: Satellites (front, center, rear): 9 x 17 x 8.6 cm (3.5 x 6.7 x 3.4 in.) Subwoofer: 15.7 x 29 x 28 cm (6.2 x 11.4 x 11 in.) • Diameter, driver(s): Satellites (front, center, rear): 7.6 cm (3 in.) Subwoofer: 12.
MANHATTAN offers a complete line of PC Components, Peripherals, Cables and Accessories. Ask your local computer dealer for more information or visit us online at ® www.manhattan-products.com Copyright © MANHATTAN All products mentioned are trademarks or registered trademarks of their respective owners.
