User's Manual

ON/OFF
LEARN
UPM
REMOTE CONTROL RECEIVER
TR310 remote control transmitter
OWNERS
MANUAL
Congratulations on your
purchase of a UPM
compact keychain remote
control transmitter. This
unit is specifically
designed to work with
UPM brand receivers.
Please take the time to
read and understand this
manual so you can begin
to enjoy the convenience
this product can offer.
FEATURES
! 433 MHz RF technology
! Intelligent code learning
! Control up to 2 remote
receivers
! Ultra compact keychain
design
! Transmission range of
up to 40 meters in open
area
LEARN FUNCTION
TROUBLESHOOTING
Transmitter stops turning
receiver on and off.
Use the LEARN function to
reprogram the receiver
or
Check the battery
problem solution
TECHNICAL SPECIFICATIONS
Battery Type: 2 x 1.5V button cell
System Source: 4,096 code combinations
Transmission Frequency: 433 MHz
Transmission Range: up to 40 meters in open area
2
3
Repeat and for an additional
receiver (available at your local
retailer) using other channel
Press LEARN on receiver while
simultaneously pressing the desired
channel button on the transmitter
TR310 Transmitter
1
1
Plug receiver into wall socket
4
If LEARN completed successfully,
the LED on the receiver should
light up when ON is pressed
1
Turn each receiver On/Off
individually by using the channel
On/Off keys on the transmitter
ON/OFF FUNCTION
3
4
2
2
The learn function must be performed to allow the receivers in your system to
recognize the transmitter. More than 4,000 code combinations eliminate the
possibility of interference by other transmitters.
Note that a generic model of receiver is used for illustration here. Please
refer to the accompanying owners manual for the operations of your
specific receiver.
*
NOTICE
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Warning:
Changes or modifications made to this equipment not expressly approved by
the manufacturer may void the FCC authorization to operate this equipment.
GETTING STARTED
battery installation
1
2
remove the battery cover from
the back of the transmitter
place two button cell batteries
into compartment observing
proper polarity then replace cover
3
the green LED will light up with any key
press once the battery is installed correctly
1
3
button descriptions
LED - signal indicator
CHANNEL 1 - ON
CHANNEL 1 - OFF
CHANNEL 2 - ON
CHANNEL 2 - OFF
1
2