WIRELESS REMOTE CONTROL USER MANUAL TR300 Transmitter RC270 Indoor Receiver for Appliance Introduction The TR300 Transmitter is designed to control our Indoor Receiver RCZ70. You can use this Transmitter to control the Receivers RC270 for any plug-in electrical appliances as well as lighting devices. The Transmitter has 4 channels, which can control! up to 4 receivers.
The system code and channel number of the Receivers will be retained if they are unplugged from the power outlet for less than 10 minutes, If the Receivers have been unplugged for too long duration, the above learn "procedures needs to be performed again, DO NOT press the RESET button of the transmitter again after setting up the Receivers unless you suspect that the Remote Control is interfered by other signals.
BUTTON CONFIGURATION Transmitter TR300 ON The 4 ON button will turn on the receiver of the respective channel OFF The 4 ON button will turn on the receiver of the respective channel BRIGHT Increase the brightness of the plugged-in lamps (only applicable for our other UPM" Brand Dimmer Receivers RC270D) DIM Decrease the brightness of the plugged-in lamps (only applicable for our other UPM "Brand Dimmer Receivers RC270D) RESET (located inside the battery compartment) Generate a new System code Appliance Recei
Period of Keven Modulated RF Carrier Model : TR300 RC270/RC270D Carrier Frequency: 433.92MHz Bit Rate: 521 bits / second Encoding: Pulse width modulation I pulse of 1.28 ms low, 0.64 ms high for logic 1 I pulse of 0.64 ms low, 1.28 ms high for logic 0 Word Format: 1/3bit + 20 bits / word Operating Period: ~~ One transmission of 4 words each time {depends on user) Specification: IX RX Frequency Range 433.92MHz 433.
WIRELESS REMOTE CONTROL USER MANUAL TR300 Transmitter RC270D Indoor Dimmer Receiver for Lighting Introduction The TR300 Transmitter is designed especially to control alt our Indoor Dimmer Receiver RC270D. With its dual mode (on/off and dimmer functions), you can use this Transmitter to control the Receivers for switching on or off, dim or bright the plugged-in lamp.
BUTTON CONFIGURATION Transmitter TR-5028 ON The 4 ON button will turn on the receiver of the respective channel OFF The 4 ON button will turn on the receiver of the respective channel BRIGHT Increase the brightness of the plugged-in lamps (only applicable for Dimmer Receivers RC270D) DIM Decrease the brightness of the plugged-in lamps (only applicable for Dimmer Receivers RC270D) RESET (located inside the battery compartment) Generate a new System code Dimmer Receiver RC270D LEARN Learn the System Code and
Repeat the above procedures if you have more than 1 Receiver. The Receivers can be set to same channel or different channels, depending on whether you want to control the Receivers together or separately. The system code and channel number of the Receivers will be retained if they are unplugged from the power outlet for less than 10 minutes. If the Receivers have been unplugged for too tong duration, the above Ida ’ procedures needs to be performed again.
Technical Specifications RC270D Dimmer Receiver Ratings: 120V 60Hz Transmission Range: 25 meters in open area Maximum Load: 300W incandescent lamp or Halogen lamp (120V) Transmitter Power Source: 9V Battery System Code: 4,096 combinations This device complies with Part 15 of the FCC Rules Operation is subjected to the following two conditions: 1. this device may not cause harmful interference, and 2. this device must accept any inference revived, including interference that may cause undesired operation.