ENGLISH: Original instructions INSTRUCTION MANUAL Job Site Charger Radio XRM10 IMPORTANT: Read Before Using.
SPECIFICATIONS Model: XRM10 AC power adaptor DC 24 V / 5.0 A, inner sleeve positive Battery UM-3 (AA size) x 2 for back up CXT battery: 10.8 V - 12 V max LXT battery: 14.4 V - 18 V Band FM AM Frequency coverage Bluetooth® FM 87.50 - 108 MHz (0.1 MHz/step) AM (MW) 520 - 1,710 kHz (10 kHz/step) ® Bluetooth ® Bluetooth QD ID D049499 ® (The Bluetooth word mark and logos are registered trademarks owned by Bluetooth SIG, Inc.
Battery capacity Battery Cartridge Voltage Operating time (hour) (at speaker output = 50 mW + 50 mW) Charging time (hour) 10.8 V - 12 V max 18 V In radio or AUX In Bluetooth® with USB charging BL1041B - *** *** *** - BL1840B *** *** *** 5.0 Ah - BL1850B *** *** *** 6.0 Ah - BL1860B *** *** *** 4.0 Ah WARNING: Only use the battery cartridges listed above. Use of any other battery cartridges may cause LQMXU\ DQG RU ¿UH NOTE: Some of the battery cartridges listed above may not b
19. 20. 21. 22. 23. 24. 25. responsible for their safety. Children should be supervised to ensure that they do not play with the product. Store the product out of the reach of children. %H FDUHIXO QRW WR SLQFK \RXU ¿QJHUV ZKHQ opening and closing the battery cover. Return the battery compartment locker to the original position, after installing or removing battery pack. If not, battery pack may accidentally IDOO RXW RI WKH UDGLR FDXVLQJ LQMXU\ WR \RX RU VRPHone around you.
11. 12. 13. 14. 15. 16. 17. 18. forwarding agents, special requirement on packaging and labeling must be observed. For preparation of the item being shipped, consulting an expert for hazardous material is required. Please also observe possibly more detailed national regulations. Tape or mask off open contacts and pack up the battery in such a manner that it cannot move around in the packaging. When disposing the battery cartridge, remove it from the tool and dispose of it in a safe place.
10. 11. 12. 13. 14. 15. 16. 17. 18. and remove battery cartridge. Pull by plug rather than cord whenever disconnecting the appliance. Do not leave the AC power adaptor disconnected from the appliance while the power is supplied from the mains. Make sure cord is located so that it will not be stepped on, tripped over, or otherwise subjected to damage or stress. Do not operate this appliance with damaged cord or plug.
INTRODUCTION Parts description Body (a) (b) (c) 1 2 4 5 7 6 3 (d) 8 3 (e) (f) 17 9 12 10 13 18 19 14 15 11 16 Fig.1 Ź D /HIW VLGH E )URQW F 5LJKW VLGH G %DFN EDWWHU\ FRYHU FORVHG H %DFN EDWWHU\ FRYHU RSHQHG I 7RS 1 Handle 2 Soft bended rod antenna 3 Speaker 4 Menu/Info button 5 Volume/Tuning control/ Select knob 6 Auxiliary input socket (AUX IN 1) 7 USB power supply port 8 DC IN socket 9 Hook for AC adaptor 10 Bottle cap opener 11 Battery cover 12 Slot
Buttons and LCD display 1 2 3 4 5 11 6 12 13 14 15 7 8 16 9 17 10 18 Fig.
To remove the battery cartridge, slide it from the tool while sliding the button on the front of the cartridge. After installing/removing the battery cartridge, be sure to close the battery cover. 2. Remove back up battery compartment cover and install 2 fresh UM-3 (AA sizes) batteries. Make sure the batteries are with correct polarity as shown inside the compartment. CAUTION: Always install the battery cartridge fully until the red indicator cannot be seen. If not, LW PD\ DFFLGHQWDOO\ IDOO RXW RI WKH WRR
Using the soft bended rod antenna When listening to FM radio stations, straight up the soft EHQGHG URG DQWHQQD DV VKRZQ LQ WKH ¿JXUH 1 1 2 3 Fig.8 Ź 1. Cover 2. DC IN socket 3. Adaptor plug NOTE: When the adaptor is used, the radio is powered from the mains and the battery cartridge is charged. Fig.7 Ź 1. Soft bended rod antenna NOTE: When the radio has any interference in AM band by its AC adaptor, move the radio away from the AC adaptor further than 30 cm (1 feet).
for comfortable listening. NOTE: No matter if the radio is AC powered or battery powered, you can charge a USB device when the radio is switched on and in FM radio mode, Bluetooth mode, or AUX mode which is appeared when an external audio source is connected. Charging with USB power supply port NOTE: The maximum volume of the output power speaker will decrease when your USB device is being charged.
NOTE: It will take several seconds until the indicator for battery status/capacity appears after the AC power adaptor is plugged into the mains. 1 NOTE: If the AC power adaptor is disconnected from the radio during battery charging, the radio turns off for a few seconds and then automatically turns on with the battery power supply. 2 Storing the AC power adaptor / external device 3 Hook for the AC power adaptor The hook on the back of the radio is useful for carrying the AC power adaptor.
Scan tuning AM/FM 1. Press the Power button radio. to switch on your 2. Press the Source button radio mode. to select AM or FM 3. Press and hold the Tuning control knob out an auto-tune. NOTE: Preset stations which have already been stored may be overwritten by following the above procedure. Recalling a preset station in AM/FM to carry Your radio will scan up the AM or FM band from the currently displayed frequency and will stop scanning autoPDWLFDOO\ ZKHQ LW ¿QGV D VWDWLRQ RI VXI¿FLHQW VWUHQJWK NO
to select the 8. Rotate the Tuning control knob desired date format (
- or ). Press the Tuning control knob WR FRQ¿UP your choice. to select or and press Tuning control knob DJDLQ WR FRQ¿UP WKH VHWWLQJ to select the 6. Rotate Tuning control knob desired volume and press Tuning control knob to con¿UP WKH YROXPH 5DGLR DODUP VHWWLQJ LV QRZ FRPSOHWHG Setting the clock time and date 1.
® Snooze Pairing your Bluetooth device When the alarm sounds, press any button other than the Power button to stop the alarm for 5 minutes. "SNOOZE" will appear on the display. 7R DGMXVW WKH VLOHQFH WLPH IROORZ WKH SURFHGXUHV EHORZ 1. Press the Source button to select Bluetooth® function. "READY BLUETOOTH" will be shown on the GLVSOD\ DQG 5($'< ZLOO ÀDVK 1. Press and hold the Menu/Info button the menu setting. INFO MENU to enter until "SNOOZE" 2.
MAINTENANCE CAUTION: Always be sure that the appliance is switched off and the battery cartridge is removed before attempting to perform inspection or maintenance. NOTICE: Never use gasoline, benzine, thinner, alcohol or the like. Discoloration, deformation or cracks may result. To maintain product SAFETY and RELIABILITY, UHSDLUV DQ\ RWKHU PDLQWHQDQFH RU DGMXVWPHQW VKRXOG be performed by Makita Authorized or Factory Service Centers, always using Makita replacement parts.
Makita Corporation 3-11-8, Sumiyoshi-cho, Anjo, Aichi 446-8502 Japan www.makita.