ENGLISH (Original instructions) INSTRUCTION MANUAL Impact Driver TD0101 TD0101F 009756 DOUBLE INSULATION WARNING: For your personal safety, READ and UNDERSTAND before using. SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
ENGLISH (Original instructions) SPECIFICATIONS Model Capacities TD0101/TD0101F Machine screw 4 mm - 8 mm Standard bolt 5 mm - 14 mm High tensile bolt 5 mm - 10 mm No load speed (min-1) 0 - 3,600 Impacts per minute (min-1) 0 - 3,200 Max. fastening torque 100 N.m Dimensions (L x W x H) 184 mm x 67 mm x 192 mm Net weight 0.99 kg Safety class II • Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
tools. Unmodified plugs and matching outlets will reduce risk of electric shock. 5. Avoid body contact with earthed or grounded surfaces such as pipes, radiators, ranges and refrigerators. There is an increased risk of electric shock if your body is earthed or grounded. 6. Do not expose power tools to rain or wet conditions. Water entering a power tool will increase the risk of electric shock. 7. Do not abuse the cord. Never use the cord for carrying, pulling or unplugging the power tool.
GEB012-4 parts. If devices are provided for the connection of dust extraction and collection facilities, ensure these are connected and properly used. Use of dust collection can reduce dust-related hazards. Power tool use and care 18. Do not force the power tool. Use the correct power tool for your application. The correct power tool will do the job better and safer at the rate for which it was designed. 19. Do not use the power tool if the switch does not turn it on and off.
Lighting up the lamp (Model TD0101F only) Installing or removing driver bit or socket bit 1. Lamp 1 009758 004521 CAUTION: Do not look in the light or see the source of light directly. Connect the plug to light up the lamp. The lamp keeps on lighting while the plug is connected. Use only bits that has inserting portion shown in the figure. For European and North & South American countries, Australia and New Zealand • A=12mm NOTE: • Use a dry cloth to wipe the dirt off the lens of lamp.
1. Bit 2. Bit-piece 3. Sleeve N.m (kgf.cm) Standard bolt 120 (1224) 100 (1020) 3 Fastening torque 009834 To remove the bit, pull the sleeve in the direction of the arrow and pull the bit out firmly. NOTE: • If the bit is not inserted deep enough into the sleeve, the sleeve will not return to its original position and the bit will not be secured. In this case, try re-inserting the bit according to the instructions above. M14 80 (816) M12 M14 60 (612) M10 40 (408) 20 (204) 0 M12 M10 M8 M8 3.
and secure the brush holder caps. screw is not damaged. Hold the tool pointed straight at the screw. • If you tighten the screw for a time longer than shown in the figures, the screw or the point of the driver bit may be overstressed, stripped, damaged, etc. Before starting your job, always perform a test operation to determine the proper fastening time for your screw. The fastening torque is affected by a wide variety of factors including the following.
Adjustable locator with bit 1. Bumper 2. Hammer case cover 1 2 009835 To use the adjustable locator with bit, remove the bumper and then install it. The bumper can be removed by pulling forward.
Makita Corporation Anjo, Aichi, Japan 884879B221 12