ENGLISH (Original instructions) INSTRUCTION MANUAL Electronic Polisher PV7000C 004418 DOUBLE INSULATION WARNING: For your personal safety, READ and UNDERSTAND before using. SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
ENGLISH (Original instructions) SPECIFICATIONS Model Max capacities PV7000C Sponge pad/ Wool bonnet 180 mm Spindle thread M14 Rated speed (n)/No load speed (n0) 600 - 2,000 min-1 Overall length 210 mm Net weight 2.1 kg Safety class /II • Due to our continuing programme of research and development, the specifications herein are subject to change without notice. • Specifications may differ from country to country.
electric shock if your body is earthed or grounded. Do not expose power tools to rain or wet conditions. Water entering a power tool will increase the risk of electric shock. 7. Do not abuse the cord. Never use the cord for carrying, pulling or unplugging the power tool. Keep cord away from heat, oil, sharp edges or moving parts. Damaged or entangled cords increase the risk of electric shock. 8. When operating a power tool outdoors, use an extension cord suitable for outdoor use.
hazards. Power tool use and care 18. Do not force the power tool. Use the correct power tool for your application. The correct power tool will do the job better and safer at the rate for which it was designed. 19. Do not use the power tool if the switch does not turn it on and off. Any power tool that cannot be controlled with the switch is dangerous and must be repaired. 20.
Safety Warnings Specific for Polishing Operations: a) Do not allow any loose portion of the polishing bonnet or its attachment strings to spin freely. Tuck away or trim any loose attachment strings. Loose and spinning attachment strings can entangle your fingers or snag on the workpiece. Additional Safety Warnings: 16. Do not leave the tool running. Operate the tool only when hand-held. 17.
FUNCTIONAL DESCRIPTION • Number 1-2 2-3 3-4 4-5 CAUTION: Always be sure that the tool is switched off and unplugged before adjusting or checking function on the tool. min-1 (RPM) 600 - 800 800 - 1,300 1,300 - 1,800 1,800 - 2,000 006415 Switch action CAUTION: If the tool is operated continuously at low speeds for a long time, the motor will get overloaded, resulting in tool malfunction. • The speed adjusting dial can be turned only as far as 5 and back to 1.
Installing side grip (auxiliary handle) & cover Installing or removing sponge pad 1. Cover 2. Side grip 1. Sponge pad 2. Pad 1 2 1 2 004422 004419 To install the sponge pad, first remove all dirt or foreign matter from the pad. Install the sponge pad to the pad. To remove the pad, pull it off from the pad slowly. 1. Cover 2. Side grip 1 Installing or removing the wool bonnet 2 1 1. Wool bonnet 2. Lock nut 3.
MAINTENANCE • CAUTION: Always be sure that the tool is switched off and unplugged before attempting to perform inspection or maintenance. Replacing carbon brushes 004426 1. Limit mark To remove the wool bonnet, follow the installation procedure in reverse. OPERATION Polishing operation by sponge pad 1 001145 Remove and check the carbon brushes regularly. Replace when they wear down to the limit mark. Keep the carbon brushes clean and free to slip in the holders.
• • • • • Sponge pad (Hook & loop) Backing pad 165 (Hook & loop) Wool bonnet 180 Wrench 17 Side grip (auxiliary handle) 9
Makita Corporation Anjo, Aichi, Japan 884356C223 12