ENGLISH (Original instructions) INSTRUCTION MANUAL Concrete Planer PC5000C PC5001C 009839 DOUBLE INSULATION WARNING: For your personal safety, READ and UNDERSTAND before using. SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
ENGLISH SPECIFICATIONS Model PC5000C Wheel diameter PC5001C 125 mm Hole diameter 22.23 mm Rated speed (n)/No load speed (n0) 10000 min-1 Overall length 437 mm Net weight 4.0 kg Safety class 479 mm 5.1 kg /II • Due to our continuing programme of research and development, the specifications herein are subject to change without notice. • Note: Specifications may differ from country to country. • Weight according to EPTA-Procedure 01/2003 END202-6 serious injury.
accessories, or storing power tools. Such preventive safety measures reduce the risk of starting the power tool accidentally. 21. Store idle power tools out of the reach of children and do not allow persons unfamiliar with the power tool or these instructions to operate the power tool. Power tools are dangerous in the hands of untrained users. 22. Maintain power tools. Check for misalignment or binding of moving parts, breakage of parts and any other condition that may affect the power tool’s operation.
. 5. 6. 7. 8. 9. 10. 11. 12. Never lay the power tool down until the accessory has come to a complete stop. The spinning accessory may grab the surface and pull the power tool out of your control. 13. Do not run the power tool while carrying it at your side. Accidental contact with the spinning accessory could snag your clothing, pulling the accessory into your body. 14. Regularly clean the power tool’s air vents.
disconnect the tool from the mains supply ( use non metallic objects ) and avoid damaging internal parts. e) Do not attach a saw chain woodcarving blade or toothed saw blade. Such blades create frequent kickback and loss of control Safety Warnings Specific for Grinding Operation: a) Use only wheel types that are recommended for your power tool and the specific guard designed for the selected wheel. Wheels for which the power tool was not designed cannot be adequately guarded and are unsafe.
push in the lock lever (B) further. To stop the tool from the locked position, pull the switch trigger (A) fully, then release it. To level a surface, the base of the planer should be aligned with the diamond wheel. The front roller should be adjusted (use hex wrench) upward to the level required for the desired stock removal amount. To change the amount of stock (concrete) removed, loosen the hex socket head bolts on the base holder with the hex wrench.
Use a square or ruler to obtain the desired base angle in relation to the diamond wheel. Then secure carefully the hex socket head bolts on either side of the base. Adjust center of base near wheel so that it is on the same level as the wheel. 2 1 Max. 6 clockwise to raise, counterclockwise to lower. ASSEMBLY 1. Same level 2. Square or ruler 3. Hex socket head bolt • CAUTION: Always be sure that the tool is switched off and unplugged before carrying out any work on the tool.
Connecting a vacuum cleaner 009881 009845 To install a dust cover's brush, put the outer edge of the dust cover's brush in the groove in the dust cover. When you wish to perform clean planing operation, connect a Makita vacuum cleaner to your tool as shown in the figure. OPERATION 009882 And then expand the groove. With the groove being expanded, insert the inner edge of the dust cover's brush. Repeat this action and insert all the remaining part.
ACCESSORIES CAUTION: These accessories or attachments are recommended for use with your Makita tool specified in this manual. The use of any other accessories or attachments might present a risk of injury to persons. Only use accessory or attachment for its stated purpose. If you need any assistance for more details regarding these accessories, ask your local Makita Service Center.
Makita Corporation 884876C1 12