ENGLISH Parts description MACAQUE, MACAQUE MACAQUE 1. Ai filer (Air int ska) 8. Quick couplet 2. Check valve 9. Albertan 3. Safely valve 10. Drain naive 4. Alr compressor pump 11. Pressure switch 5. Regulator 12. Power cord 6. Tank pressure gauge 13. AUTOMATON-OFF switch 7. Outer pressure gauge 14. Pressure switch unloading valve Note: The shape of the drain valve differs between MACAQUE and MACAQUE.
SPECIFICATIONS Model MACAQUE MACAQUE MACAQUE MAX Output Power 350 W 800W 1M100wW SCAM @ 0 PSI 07 20 28 Cut-In Pressure 105 PSI (0.72 MPa) Cut-Out Pressure. 135 PSI (0.93 MP8) Bore x Stroke x Qty 51 mmx8mmx2 64 mmx 14 mm 64 mmx 17 mmx 2 Voltage Single Phase 120VAG Hz 60 Hz Motor RPM 1,750 min” Lubrication Oli Less Tank Size gal (3.8L) 2gal(78L) 3gal(M4L) Wright 12.5 kg (27.6 Ibs) 20.5 kg (45.2 Ibs) 23.8 kg (52.
IMPORTANT SAFETY INSTRUCTIONS SAVE THESE INSTRUCTIONS. A WARNING IMPROPER OPERATION OR MAINTENANCE OF THIS PRODUCT COULD RESULT IN SERIOUS INJURY AND PROPERTY DAMAGE. READ AND UNDERSTAND ALL WARNINGS AND ‘OPERATING INSTRUCTIONS BEFORE USING THIS EQUIPMENT. WARNING Risk of Unsafe Operation WHAT CAN HAPPEN Unsafe aspiration of your alr compressor could lead to serious Injury to you or others.
The alr stream may contain carbon monoxide or other vapors, or pesticides from the tank or other components. Sprayed materials such as paint, paint solvents, paint remover, Insecticides, weed killers, etc, contain harmful vapors and poisons. Breathing compressor or sprayed materials vapor can result in serious injury. HOW TO PREVENT IT Never Inhale alr from the compressor, ether directly or from a breathing device connected to the compressor.
Immediately upon arrival, check equipment for bath concealed and visible damages to avoid expenses being incurred to correct such problems. This should be done regardless of any visible neigh of damage to the shipping container. If this product was shipped directly to you, report any damages to the carer and arrange for inspection of goods immediately. STORAGE Before you store the alr compressor, make sure you do the following: 1.
that wil Interfere wih the flow of alr. The air compressor head and shroud are designed to allow for proper cooling. If humidity is high, an air filter can be installed on the air ‘outlet adapter to remove excessive moisture. Follow the Instructions packaged with the alr tier for proper Installation. Pace the air compressor on a fiat surface so they iris resting securely on the rubber foot OPERATING TEMPERATURE The operating temperature of this compressor Is between 0°C and 40°C (32°F and 104°F).
When you are finished: DISCONNECTING HOSES WARNING Risk of unsafe operation. Dimly grasp hose In hand when Installing or disconnecting to prevent hiss whip. Losing control of the hose may result In personal Injury and property damage. 6. Set the pressure cliche lever to “OFF”. 7. Using the alr too! or accessory, breed the tank pressure down fo zero. Remove the air tool or accessory. Drain water from alr tank by opening drain cock valve on bottom of tank. WATER WILL CONDENSE IN THE AIR TANK.
automatiquement C'est ca qu'on appels la « pression de réalimentation » PRESSION DE COUPURE : Lorsque vous démarrez le ‘compresseur d'si, il commence a fonctionner et la pression du réservoir d'air commence & augmenter. Elle augments Jusqu’a un certain niveau, pulls (e moteur ‘amie automatiquement ce qul &vite que Ie réservoir air soit soumis & une pression supérieure & cale pour Laquelle Ii a 616 congru.