ENGLISH (Original instructions) INSTRUCTION MANUAL Angle Grinder M9002 M9003 015065 DOUBLE INSULATION IMPORTANT: Read Before Using.
ENGLISH (Original instructions) SPECIFICATIONS Model M9002 M9003 Depressed center wheel diameter 125 mm 150 mm Max. wheel thickness 6 mm Spindle thread M14 or 5/8" (country specific) Rated speed (n) / No load speed (n0) 11,000 min-1 10,000 min-1 Overall length 361 mm 361 mm Net weight 2.8 kg 2.8 kg Safety class /II • Due to our continuing program of research and development, the specifications herein are subject to change without notice.
ENG902-1 • • • • GEA005-3 The declared vibration emission value has been measured in accordance with the standard test method and may be used for comparing one tool with another. The declared vibration emission value may also be used in a preliminary assessment of exposure. The declared vibration emission value is used for main applications of the power tool. However if the power tool is used for other applications, the vibration emission value may be different.
22. Maintain power tools. Check for misalignment or binding of moving parts, breakage of parts and any other condition that may affect the power tool’s operation. If damaged, have the power tool repaired before use. Many accidents are caused by poorly maintained power tools. 23. Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting edges are less likely to bind and are easier to control. 24. Use the power tool, accessories and tool bits etc.
6. 7. 8. 9. 10. 11. 12. 13. Do not run the power tool while carrying it at your side. Accidental contact with the spinning accessory could snag your clothing, pulling the accessory into your body. 14. Regularly clean the power tool’s air vents. The motor’s fan will draw the dust inside the housing and excessive accumulation of powdered metal may cause electrical hazards. 15. Do not operate the power tool near flammable materials. Sparks could ignite these materials. 16.
24. Safety Warnings Specific for Grinding Operation: a) Use only wheel types that are recommended for your power tool and the specific guard designed for the selected wheel. Wheels for which the power tool was not designed cannot be adequately guarded and are unsafe. b) The grinding surface of centre depressed wheels must be mounted below the plane of the guard lip. An improperly mounted wheel that projects through the plane of the guard lip cannot be adequately protected.
To stop the tool from the locked position, pull the switch trigger fully, and then release it. FUNCTIONAL DESCRIPTION • ASSEMBLY CAUTION: Always be sure that the tool is switched off and unplugged before adjusting or checking function on the tool. • Shaft lock • CAUTION: Never actuate the shaft lock when the spindle is moving. The tool may be damaged. Installing side grip (handle) • 1.
Installing or removing depressed center grinding wheel/Multi-disc (optional accessory) • • • WARNING: Always use supplied guard when depressed center grinding wheel/Multi-disc is on tool. Wheel can shatter during use and guard helps to reduce chances of personal injury. 1 2 3 • CAUTION: Never switch on the tool when it is in contact with the workpiece, it may cause an injury to operator. Always wear safety goggles or a face shield during operation.
Replacing carbon brushes 1. Limit mark 1 001145 Remove and check the carbon brushes regularly. Replace when they wear down to the limit mark. Keep the carbon brushes clean and free to slip in the holders. Both carbon brushes should be replaced at the same time. Use only identical carbon brushes. 1. Brush holder cap 2. Screwdriver 1 2 015051 Use a screwdriver to remove the brush holder caps. Take out the worn carbon brushes, insert the new ones and secure the brush holder caps.
Makita Jan-Baptist Vinkstraat 2, 3070, Belgium Makita Corporation Anjo, Aichi, Japan 885412-222 12 www.makita.